ISO 16079-2-2020 PDF

ISO 16079-2-2020 PDF

Condition monitoring and diagnostics of wind turbines-Part 2: Monitoring the drivetrain

$129.00 $258.00 -50%
Product Code: ISO 16079-2
Stock In Stock
Edition: 1ST
Published: 09/2020
Number of Pages: 54
File Size: 1 file, 5 Bytes

Available Options

Product Description

Condition monitoring and diagnostics of wind turbines — Part 2: Monitoring the drivetrain

Introduction: This document is the second step of the procedure for carrying out the CM and D application design phase according to the V-model of ISO 13379-1. In this step, the monitoring strategy for the drivetrain is defined, based upon the prioritized failure modes which were the outcome of the failure modes, effect and criticality analysis (FMECA) procedure performed according to ISO 16079-1 (see Figure 1). According to the V-Model of ISO 13379-1 and ISO 16079-1, the steps described in this document are as follows: a) decide under which operating conditions the different faults can be best observed and specify the conditions under which the symptom is most likely to be observed; b) identify the symptoms that can serve in assessing the condition of the machine, and that are used for diagnostics; c) list the descriptors that are used to evaluate (recognize) the different symptoms; d) identify the necessary measurements and transducers from which the descriptors are derived or computed. Key dotted line scope of this document Figure 1 — The relationship between this document and ISO 16079-1 In relation to the V-model, this document describes the two last steps of the application design phase of the condition monitoring system. This process shall ensure that data are available to support an vi © ISO 2020 – All rights reserved

Scope: This document specifies the implementation of a condition monitoring system for wind turbines, with particular focus on monitoring of the drivetrain. Guidance for a practical implementation of the FMSA is provided, as well as guidance for specifying best practices and minimum recommendations regarding the condition monitoring system used for failure mode detection, diagnostics and prognostics of the direct drive and geared wind turbine drivetrain, including: a) main bearing(s); b) gearbox, if applicable; and c) generator (mechanical aspects). This also includes subcomponents such as coupling and the lubrication system. This document provides an overview of the important aspects of condition monitoring of wind turbines and makes references to other standards where in-depth information on the subjects is available.

Be the first to write a review for this product.

Write a review

Note: HTML is not translated!
Bad           Good
ISO 16079-2-2020 PDF

ISO 16079-2-2020 PDF

$129.00 $258.00