Matériel agricole et forestier - Contrôle des pulvérisateurs en service - Partie 1: Généralités
Introduction: There are two main reasons for the inspection of sprayers: — reducing the potential risk of environmental contamination by plant protection products; — good control of the pest with the minimum possible input of plant protection product. In order to use plant protection products in agricultural production safely, it is necessary to define the requirements and test methods for sprayers in use. This is a relevant step after having standardized minimum requirements for new sprayers, in respect of safety hazards (see ISO 4254-6) and potential risks of environmental contamination (see ISO 16119 series). Standardising the requirements and methods for inspection of sprayers in use takes into consideration not only the original performance of the sprayer but also its use, care, and maintenance. This is a logical link to ensure the continued benefit arising from the supply of new sprayers of good quality. The inspection of sprayers in use can be a mandatory requirement or adopted on a voluntary basis. In both cases, further requirements outside the scope of this document are necessary for the management of inspections. These include, for example, requirements for the competence of persons carrying out inspections and the frequency of inspections. NOTE National or local regulations concerning the qualifications and competence of inspectors can apply. © ISO 2024 – All rights reserved
Scope: This document defines the general requirements to be fulfilled for the inspection of all types of sprayers for plant protection products used in agriculture, horticulture, forestry and other areas, except knapsack sprayers. NOTE For knapsack sprayers, see ISO/FDIS 19932–3:—. The specific requirements for the different types of sprayers are defined in the relevant specific parts of the ISO 16122 series. When used in conjunction with the relevant sprayer specific part (see Annex A), this document specifies the requirements and test methods for the inspection of sprayers in use. The requirements relate mainly to the condition of the sprayer with respect to potential risks for the environment and its performance to achieve a good application. This document also includes minimum requirements for the preparation of the sprayer for the inspection and the minimum safety requirements with respect to the safety of the inspector (test operator) during the inspection.