ISO 16148-2016 PDF

ISO 16148-2016 PDF

Gas cylinders - Refillable seamless steel gas cylinders and tubes - Acoustic emission examination (AT) and follow-up ultrasonic examination (UT) for periodic inspection and testing

$13.00 $26.00 -50%
Product Code: ISO 16148
Stock In Stock
Edition: 2ND
Published: 04/15/2016
Number of Pages: 34
File Size: 1 file, 639 Bytes

Available Options

Product Description

Gas cylinders - Refillable seamless steel gas cylinders and tubes - Acoustic emission examination (AT) and follow-up ultrasonic examination (UT) for periodic inspection and testing

Introduction: In recent years, new non-destructive examination (NDE) techniques have been successfully introduced as an alternative to the conventional testing procedures of gas cylinders, tubes and other cylinders at the time of periodic inspection and testing. One of the alternative NDE methods for certain applications is acoustic emission examination (AT), which has proved to be an acceptable test method applied during periodic inspection and testing in some countries. The test method requires pressurization to a level greater than the normal filling pressure. The pressurization medium can be either gas or liquid. Acoustic emission (AE) measurements are used to detect and locate emission sources. Other NDE methods are needed to evaluate the significance of AE detected sources. One of the alternative NDE methods used as a follow-up to AT is ultrasonic examination (UT), which has proved to be an acceptable testing method applied during periodic inspection and testing. The purpose of this International Standard is to provide a procedure for locating, detecting and evaluating the relevance of AE indications such as those from longitudinally oriented crack-like discontinuities. The shear wave (angle beam) UT method is intended to be used immediately following AT to evaluate the significance of AE indications. This International Standard describes two methods of AT, defined as Method A and Method B, and a method of follow-up UT. With the agreement of the testing and certifying body approved b

Scope: This International Standard gives procedures for the use of acoustic emission examination (AT) and ultrasonic examination (UT) follow-up during the periodic inspection and testing of seamless steel cylinders and tubes with a water capacity of up to 3 000 l used for compressed and liquefied gases. This examination provides acoustic emission (AE) indications and locations that are evaluated by a secondary examination using UT for a possible flaw in the cylinder or tube. Methods other than UT for the secondary examination are not covered by this International Standard. This International Standard does not cover composite cylinders. CAUTION — Some of the tests specified in this International Standard involve the use of processes which could lead to a hazardous situation.

Be the first to write a review for this product.

Write a review

Note: HTML is not translated!
Bad           Good
ISO 16148-2016 PDF

ISO 16148-2016 PDF

$13.00 $26.00