Corrosion protection of steel structures by protective paint systems — Assessment of, and acceptance criteria for, the adhesion/cohesion (fracture strength) of a coating — Part 1: Pull-off testing
Introduction: The main purpose of this document is to supplement the ISO 12944 series with regard to the field assessment of, and acceptance criteria for, the adhesion/cohesion of a coating. To comply with this document, laboratory testing of panels can be required. This document introduces the term fracture strength, which includes both adhesion and cohesion. Adhesion and cohesion are defined in ISO 4618, whereas the ISO 12944 series uses the term “adhesion” only. This document applies to the assessment of pull-off testing of paint coatings on steel structures on site. ISO 4624 specifies a pull-off test for laboratory use, without instructions for interpretation of the results and without acceptance or rejection criteria. Fracture strength testing is normally destructive and therefore requires repair work, the extent of which will depend on the specification and the durability required of the protective paint coating. This document aims to provide uniformity in the assessment of the fracture strength of a coating and to establish acceptance/rejection criteria for protective paint coatings. The method specified in this document uses test equipment based on the pull-off principle; push-off adhesion testing is excluded. Protective paint systems which have poor adhesion/cohesion normally fail at fracture strength values significantly lower than the values quoted in the specification. For a protective paint system with a particular fracture strength, a range of test values are obtained from di
Scope: This document specifies procedures for assessing the fracture strength of a protective paint coating of any thickness on a steel substrate of thickness not less than 3 mm. The procedures given in document are based on methods used with different types of pull-off test equipment. The results obtained using such different types of equipment are not comparable. This document is only applicable if a fracture strength value is specified, together with the type of test equipment and the manufacturer of the equipment. Usually, this information is included in contract documentation. This document also specifies suitable equipment and defines inspection areas, sampling plans and acceptance/rejection criteria. It does not give any values of the fracture strength of different protective paint coatings.