Rolling bearings — Methods for calculating the modified reference rating life for universally loaded rolling bearings
Introduction: Since publication of the first edition of ISO 281:1990, additional knowledge has been gained regarding the influence on bearing life of contamination, lubrication, internal stresses from mounting, stresses from hardening, fatigue load limit of the material etc. It is therefore now possible to consider factors that have influence on bearing life in a more complete way in the life calculation. ISO 281 provides a method to put into practice this new knowledge in a consistent way when the modified rating life of a bearing is calculated. However, the calculation method given in ISO 281 cannot consider the influence on life of tilted or misaligned bearings and the influence on life of bearing clearance during operation. ISO/TS 16281:2008 already describes an advanced calculation method, which makes it possible to consider these influences, and in addition provides the most accurate method for estimating the influence of contamination and other factors. In addition to the content of ISO/TS 16281:2008, this document also addresses the analysis of hybrid bearings with rolling elements made of silicon nitride. The primary purpose of this document is to provide a unified and manufacturer-independent advanced calculation method that allows for the consideration of actual operating conditions, thus enabling the end user to compare different bearing solutions on the same calculation basis. It is also intended to serve as a manufacturer-independent neutral basis for certification purposes,
Scope: This document defines the calculation of the modified reference rating life taking into consideration lubrication, contamination, and fatigue load limit of the bearing material, as well as tilting or misalignment, operating clearance of the bearing and internal load distribution on rolling elements. The calculation method provided in this document covers influencing parameters additional to those described in ISO 281. The general directions and limitations given in ISO 281 apply to this document. The calculation methods pertain to the fatigue life of the bearings. Other mechanisms of failure, like wear or microspalling (gray- staining), lie outside the scope of this document. This document applies to single- and multi-row radial and thrust ball bearings, subjected to radial and axial load and with radial clearance and tilt taken into account. It also applies to single- and multi-row radial and thrust roller bearings, subjected to radial and axial load and with radial clearance, edge stress and tilt taken into account. References to methods for the analysis of the internal load distribution under general load are given. The calculation of load distribution and basic reference rating life is also applicable to hybrid bearings, using the dynamic load ratings per ISO 20056-1[2]. The calculation of the modified reference rating life is not applicable to hybrid bearings.