ISO 16396-1-2022 PDF

ISO 16396-1-2022 PDF

Plastics-Polyamide (PA) moulding and extrusion materials-Part 1: Designation system and basis for specifications

$60.00 $120.00 -50%
Product Code: ISO 16396-1
Stock In Stock
Edition: 2.
Published: 09/2022
Number of Pages: 24
File Size: 1 file, 1 Byte

Available Options

Product Description

Plastiques - Matériaux polyamides (PA) pour moulage et extrusion - Partie 1: Système de désignation, marquage des produits et base de spécification

Introduction: In practice, ISO 1043 and ISO 11469 are, in combination, being "improperly" used as a designation system for, e.g. marking. The aim of this document is to simplify the data block system and to connect more to ISO 1043 and ISO 11469, where the first two blocks are used for generic identification and marking of products. © ISO 2022 – All rights reserved

Scope: This document establishes a system of designation for polyamide (PA) moulding and extrusion materials, which can be used as the basis for specifications. The types of polyamide plastics are differentiated from each other by a classification system based on appropriate levels of the designatory properties a) viscosity number, b) tensile modulus, and c) nucleating additive, and on information about composition, intended application and/or method of processing, important properties, additives, colorants, fillers, and reinforcing materials. The designation system is applicable to all polyamide homopolymers, copolymers, and blends. It is applicable to unmodified materials ready for normal use and materials modified, for example, by colorants, additives, fillers, reinforcing materials, and polymer modifiers. This document does not apply to the following materials: — monomer casting-type polyamides of PA 6; — monomer casting-type polyamides of PA 12. It is not intended to imply that materials having the same designation give the same performance. This document does not provide engineering data, performance data, or data on processing conditions which can be required to specify a material. If such additional properties are required, they can be determined according to the test methods specified in ISO 16396-2, if suitable. In order to specify a thermoplastic material for a particular application, additional requirements can be given in data block 5 (see 4.1).

Be the first to write a review for this product.

Write a review

Note: HTML is not translated!
Bad           Good
ISO 16396-1-2022 PDF

ISO 16396-1-2022 PDF

$60.00 $120.00