ISO 16834-2025 PDF

ISO 16834-2025 PDF

Welding consumables-Wire electrodes, wires, rods and deposits for gas shielded arc welding of high strength steels-Classification

$71.50 $143.00 -50%
Product Code: ISO 16834
Stock In Stock
Edition: 3.
Published: 02/2025
Number of Pages: 24
File Size: 1 file, 1 Byte

Available Options

Product Description

Welding consumables — Wire electrodes, wires, rods and deposits for gas shielded arc welding of high strength steels — Classification

Introduction: This document recognizes that there are two somewhat different approaches in the global market to classifying a given wire electrode, wire, rod or deposit, and allows for either or both to be used to suit a particular market need. Application of either type of classification designation (or of both where suitable) identifies a product as classified in accordance with this document. The classification in accordance with system A was originally based on EN 12534:1999 which has been withdrawn and replaced by this document. The classification in accordance with system B is mainly based upon standards used around the Pacific Rim. Future revisions will aim to merge the two systems into a single classification system. This document provides a classification for the designation of wire electrodes, wires, rods and deposits in terms of their chemical composition and, where required, in terms of the yield strength, tensile strength and elongation of the all-weld metal. The ratio of yield to tensile strength of weld metal is generally higher than that of the parent metal. Users should note that matching weld metal yield strength to parent metal yield strength does not necessarily ensure that the weld metal tensile strength matches that of the parent material. Thus, where the application requires matching tensile strength, selection of the consumable should be made by reference to Table 2 System A or System B, as appropriate. © ISO 2025 – All rights reserved

Scope: This document specifies requirements for classification of wire electrodes, wires, rods and all-weld metal deposits in the as-welded condition and in the post-weld heat-treated (PWHT) condition for gas shielded metal arc welding and tungsten inert-gas welding of high-strength steels with a minimum yield strength greater than 500 MPa, or a minimum tensile strength greater than 570 MPa. One wire electrode can be tested and classified with different shielding gases. This document is a combined specification providing for classification utilizing a system based upon the yield strength and the average impact energy of 47 J of all-weld metal, or utilizing a system based upon the tensile strength and the average impact energy of 27 J of all-weld metal. a) Clauses, subclauses and tables which carry the suffix “System A” are applicable only to wire electrodes, wires, rods and deposits classified according to the system based upon the yield strength and the average impact energy of 47 J of all-weld metal under this document. b) Clauses, subclauses and tables which carry the suffix “System B” are applicable only to wire electrodes, wires, rods and deposits classified according to the system based upon the tensile strength and the average impact energy of 27 J of all-weld metal under this document. c) Clauses, subclauses and tables which do not have either the suffix “System A” or “System B” are applicable to all wire electrodes, wires, rods and deposits classified under this document. Annex A gives information on the description of composition designations for electrodes in the classification system based upon tensile strength and average impact energy of 27 J – System B.

Be the first to write a review for this product.

Write a review

Note: HTML is not translated!
Bad           Good
ISO 16834-2025 PDF

ISO 16834-2025 PDF

$71.50 $143.00