Test methods for evaluating degradation of characteristics of cleanable filter media
Introduction: The main purpose of using cleanable filter is, of course, to separate dust particles from dirty gases. They are usually designed to be usable for as long as two years to four years. However, it is very hard to design and/or select filter media properly, since their important characteristics of collection performance and residual pressure drop change with operation time. Physical and chemical properties of filter media, such as degradation in tensile strength, tenacity and so on, also change with time. Those changes can damage filter media and this can result in the breakage of bag filters and leakage of dust to the atmosphere. Hence the evaluation of these performances is also important for the rational design and the selection of appropriate filter media. ISO 11057:2011 has been published to meet the demand for the evaluation of filtration characteristics. Changes in physical and chemical properties of filter media are caused by many factors, such as heat, corrosive gases, and mechanical reasons like clogging weave openings and increasing size of weave openings, the combination of those factors and so on (see Annex A). These changes are mostly adverse effects to filter media. Degradation proceeds very slowly, and thus, it takes a long time before recognizable and/or measurable change appears. Furthermore, the appearance of change depends on the combination of causes and fibre material. These facts are the main reason why mechanism of property changes has not been well unders
Scope: This International Standard specifies a standard reference test method useful to assess the relative degradation characteristics of cleanable filter media for industrial applications under standardized simulated test conditions. The main purpose of testing is to obtain the information about relative change of properties of filter media due to exposure to the simulated gas conditions for a long time. The main target of this International Standard is the property change of nonwoven fabric filters because they are frequently used under similar circumstances to the test gas conditions described in this International Standard. The results obtained from this test method are not intended for predicting the absolute properties of full scale filter facilities. However, they are helpful for the design of a bag filter and selection and development of appropriate cleanable filter media, and for the identification of suitable operating parameters.