Respiratory protective devices - Methods of test and test equipment - Part 10: Resistance to ignition, flame, radiant heat and heat
Introduction: This part of ISO 16900 is intended as a supplement to the relevant performance standards for respiratory protective devices. Test methods are specified for complete or parts of devices. If deviations from the test method given in this part of ISO 16900 are necessary, these deviations will be specified in the relevant performance standard. The following definitions apply in understanding how to implement an ISO International Standard and other normative ISO deliverables (TS, PAS, IWA): — “shall” indicates a requirement; — “should” indicates a recommendation; — “may” is used to indicate that something is permitted; — “can” is used to indicate that something is possible, for example, that an organization or individual is able to do something. 3.3.1 of the ISO/IEC Directives, Part 2 (sixth edition, 2011) defines a requirement as an “expression in the content of a document conveying criteria to be fulfilled if compliance with the document is to be claimed and from which no deviation is permitted”. 3.3.2 of the ISO/IEC Directives, Part 2 (sixth edition, 2011) defines a recommendation as an “expression in the content of a document conveying that among several possibilities one is recommended as particularly suitable, without mentioning or excluding others or that a certain course of action is preferred, but not necessarily required, or that (in the negative form) a certain possibility or course of action is deprecated but not prohibited”. © ISO 2015 – All rights reserved
Scope: This part of ISO 16900 specifies the methods for resistance to ignition, flame, radiant heat, and heat.