ISO 16957-2016 PDF

ISO 16957-2016 PDF

Measurement of apparent thermal conductivity of wet porous building materials by a periodic method

$96.50 $193.00 -50%
Product Code: ISO 16957
Stock In Stock
Edition: 1ST
Published: 06/15/2016
Number of Pages: 28
File Size: 1 file, 1000 Bytes

Available Options

Product Description

Measurement of apparent thermal conductivity of wet porous building materials by a periodic method

Introduction: Most building materials, with the exception of glass and metals, are porous and, thus, absorb moisture due to condensation, rain and water uptake from the ground. The absorbed moisture may damage the materials through, e.g. rotting or frost damage and, thus, may cause their performance to deteriorate. In particular, an increase in the moisture content of insulation material causes a reduction of its thermal resistance, which must be avoided as much as possible to preserve its performance. However, infiltration of rain water into a brick wall or joints of tiles and uptake of ground water into the foundation (footing) are very difficult to avoid. Therefore, it is important to understand the changes in the thermal properties (thermal conductivity and heat capacity) of porous materials due to changes in their moisture content. ISO 10051 specifies a steady-state method for measuring the thermal conductivity of a moist building material. In the steady-state method, a nonuniform distribution of moisture content in the test piece is inevitable, since the imposed temperature gradient causes moisture transfer. The nonuniform moisture distribution makes it difficult to define which moisture content the measured thermal conductivity corresponds to. ISO 10051 categorizes the moisture distribution in the test piece into several types and estimates the thermal conductivity corresponding to each type. Since theoretical and experimental research has recently been performed concerning heat and

Scope: This International Standard describes a method of measuring the thermal conductivity (diffusivity) of a wet porous building material and a method of evaluating the measurement uncertainty. While ISO 10051 is the current International Standard, based on a steady-state method, this International Standard proposes a method that makes use of a non-steady-state method which uses a small temperature change with a short period as an input. Along with the measurement, an evaluation of the measurement uncertainty is described, which makes possible a simple and practical measuring method. This International Standard intends to measure the apparent (effective) thermal conductivity, including latent heat transfer caused by vapour movement. The situation in which moisture and/or air movement occur due to convection or gravity is excluded. The application of this International Standard to high moisture content is excluded so that the gravity effect can be neglected. This International Standard can be applied to a porous material heavier than about 100 kg/m3, in which radiative heat transfer can be neglected. This International Standard specifies the following: a) a non-steady-state method of measuring thermal conductivity; b) an approximation formula for the measurement uncertainty caused by moisture movement and nonuniform moisture distribution (and, thus, a determination of the measuring conditions that satisfy the upper limit of measurement uncertainty); c) an estimate of the heat transfer caused by moisture (vapour) movement.

Be the first to write a review for this product.

Write a review

Note: HTML is not translated!
Bad           Good
ISO 16957-2016 PDF

ISO 16957-2016 PDF

$96.50 $193.00