Cranes - Safety - Load lifting attachments
Introduction: This International Standard covers a wide range of non-fixed load lifting attachments which have never previously been standardized by ISO. The lack of previous standards as a starting point, together with the wide scope of the equipment covered and the wide variety of current practices, among the established manufacturers made this International Standard particularly difficult to draft and to get agreement on. Nevertheless, considerable progress has been made up to the point where the parties involved are now sufficiently in agreement to enable the first draft of this International Standard to be prepared. The ISO technical subcommittee SC 9 which is responsible for the preparation of this International Standard is of the view that while further development may be required, this International Standard, in its present form, contains much useful information to guide the manufacturers and it represents an important step forward. Experience of applying this International Standard will doubtless reveal some matters which, with the benefit of hindsight, have not been adequately dealt with and will need to be reconsidered in the next edition. In particular, readers are advised to exercise a degree of caution about the rigour of some of the verification clauses. © ISO 2015 – All rights reserved
Scope: This International Standard specifies safety requirements for the following non-fixed load lifting attachments for cranes, hoists, and manually controlled load manipulating devices as defined in Clause 3: — plate clamps; — vacuum lifters; — self priming, — non-self-priming (pump, venturi, turbine); — electric lifting magnets (battery-fed and main-fed); — permanent lifting magnets; — electro-permanent lifting magnets; — lifting beams/spreader beams; — C-hooks; — lifting forks; — clamps. This International Standard does not specify the additional requirements for the following: a) load lifting attachments in direct contact with foodstuffs or pharmaceuticals requiring a high level of cleanliness for hygiene reasons; b) hazards resulting from handling hazardous materials (e.g. explosives, hot molten masses, radiating materials); c) hazards caused by operation in an explosive atmosphere; d) hazards caused by noise; e) electrical hazards; f) hazards due to hydraulic and pneumatic components. This International Standard does not cover attachments intended to lift people. This International Standard does not cover slings, ladles, expanding mandrels, buckets, grabs or grab buckets, and container spreaders.