Water quality — Determination of the toxicity of water samples on the embryo-larval development of the Japanese oyster (Magallana gigas) and the blue mussel (Mytilus edulis or M. galloprovincialis)
Introduction: Traditionally, the level of pollution affecting a marine environment is shown in terms of the concentration levels of the contaminants present in the environment of interest. However, these measurements do not provide an estimation of the harmful effects on organisms and have to be complemented with the biological responses obtained through bioassays (see Reference [5]). Among the marine organisms used to assess the potential impact of chemicals or discharges into the environment, bivalve embryos and larvae are, together with sea urchins, among the organisms which are most frequently used in bioassays (see References [18] and [21]). The embryos and larvae are more sensitive to pollutants than the adults of the same species. Therefore, they represent the critical stages for the toxicity tests (see References [19] and [30]). Since 1972, it is recommended to use the Pacific oyster, Magallana gigas, to assess the quality of seawater (see Reference [35]). Furthermore, their worldwide distribution in coastal waters, as well as their commercial importance (see Reference [10]), make bivalves the species of choice for the undertaking of bioassays. The results of these bioassays demonstrate the necessity to determine the potential toxicity thresholds of chemicals which can enter the marine environment either accidentally or chronically, as well as the “biological quality” of an environment or the potential toxicity of river water or a discharge that reach the sea. Potential toxicity ha
Scope: This document specifies a method for assessing the effects of chemical and aqueous samples on the embryo- larval development of marine bivalves. This method allows the determination of the concentration levels that result in an abnormality in embryo-larval development. This test is suitable for salinity ranges: — between 20 PSU (practical salinity unit) and 40 PSU for mussels, and — between 25 PSU and 35 PSU for oysters. This method in this document applies to: — chemical substances and preparations, — marine and brackish waters, — streams and aqueous effluents (urban, agricultural, industrial effluents, etc.) as long as the salinity is adjusted or dilution is limited so that the aforementioned salinity ranges are respected, — aqueous extracts (pore water, elutriates, eluates and leachates) from sediments and petroleum products, and — samples of contaminated sediment or dredged material (see Annex C).