ISO 17248-2015 PDF

ISO 17248-2015 PDF

Corrosion of metals and alloys - Test method for high temperature corrosion testing of metallic materials by embedding in salt, ash, or other solids

$71.50 $143.00 -50%
Product Code: ISO 17248
Stock In Stock
Edition: 1ST
Published: 04/15/2015
Number of Pages: 22
File Size: 1 file, 289 Bytes

Available Options

Product Description

Corrosion of metals and alloys - Test method for high temperature corrosion testing of metallic materials by embedding in salt, ash, or other solids

Introduction: In contrast to high temperature corrosion occurring in a gaseous environment, which is covered in ISO 21608 and ISO 13573, this International Standard focuses on high temperature corrosion occurring on materials that are in direct contact with solid corrosive substances, commonly referred to as under- deposit corrosion. This International Standard considers the case of a metallic material embedded, partially or completely, in a corrosive powder that is present in abundance and remains completely or partially in the solid state throughout high temperature exposure. Partially embedded test pieces offer the advantage of allowing investigation of corrosion at three different positions, i.e. under the powder, at the powder/gas phase interface, and in the gas phase above the corrosive powder. The closely-related condition involving immersion in a molten salt or other liquid is described in ISO 17245, and that involving application of a surface deposit of salt, ash, or other substances in ISO 17224. © ISO 2015 – All rights reserved

Scope: This International Standard specifies the method for high temperature corrosion testing of metallic materials by embedding in a corrosive powder made up of salt, ash, and/or other solids and exposing them to high temperature in a controlled gas environment to evaluate their corrosion resistance. Two options exist: fully embedding and partially embedding. Fully embedding is used in cases in which a mass change measurement is required. Partially embedding is used to investigate three potentially different interaction zones on a single test piece, i.e. the embedded part, the non-embedded part, and the gas/powder interface region. Therefore, gravimetric measurements are not appropriate and metallographic investigations are necessary instead. This International Standard does not cover methods where test pieces are immersed in a liquid or cases in which a surface deposit is applied to the test pieces. These methods are covered in ISO 17245 and ISO 17224, respectively.

Be the first to write a review for this product.

Write a review

Note: HTML is not translated!
Bad           Good
ISO 17248-2015 PDF

ISO 17248-2015 PDF

$71.50 $143.00