Fabrication additive - Principes généraux - Partie 3: Principales caractéristiques et méthodes d’essai correspondantes
Introduction: Additive manufacturing is a process of joining bulk raw materials to make parts from 3D model data, usually layer upon layer, as opposed to subtractive manufacturing and formative methodologies. It is an inherent part of the parts development or production process. It is used to manufacture prototypes and production parts. This part of ISO 17296 aims to offer recommendations and advice to machine manufacturers, feedstock suppliers, machine users, part providers, and customers, to improve communication between these stakeholders concerning test methods. This International Standard has been developed within a set of consistent documents from terminology to test methods and data exchange. The manufacturing of parts by additive manufacturing processes is subject to numerous variables. The processes described in ISO 17296-2 can be used to manufacture parts that meet technological requirements only if these factors are controlled, optimized and, if necessary, customized for each order. When assessing parts quality, comparison with the specific requirements is one of the most important aspects. Additive manufacturing processes require the selective application of thermo-physical and/or chemical mechanisms to generate the part. Thus it is possible to produce parts with different characteristics, depending on the method used and the process parameters. However, complete testing of all parts characteristics is neither cost-effective nor technologically feasible. Therefore, when formula
Scope: This part of ISO 17296 covers the principal requirements applied to testing of parts manufactured by additive manufacturing processes. This part of ISO 17296 — specifies main quality characteristics of parts, — specifies appropriate test procedures, and — recommends the scope and content of test and supply agreements. This part of ISO 17296 is aimed at machine manufacturers, feedstock suppliers, machine users, part providers, and customers to facilitate the communication on main quality characteristics. It applies wherever additive manufacturing processes are used.
Contents:
- Foreword
- Introduction
- Scope