Workplace air — Determination of organonitrogen compounds in air using liquid chromatography and mass spectrometry — Part 1: Isocyanates using dibutylamine derivatives
Introduction: Isocyanates are organic compounds containing the isocyanate functional group (–N=C=O) and have been used in industry for about 50 years. They are commercially important chemicals mainly used for the production of polyurethane (PUR). In spite of controls to limit exposures, there are adverse health effects such as asthma, contact dermatitis and hypersensitivity pneumonitis as consequences of exposure to isocyanates in some industrial sectors. The analytical method for the determination of isocyanates in workplace air must be sensitive due to the high irritation and sensitization properties of isocyanates. Extremely low occupational exposure limits (OELs) exist in many countries, and concentrations well below the OEL, often less than one hundredth of the limit, are often to be determined. Isocyanates are very reactive and therefore cannot be analysed directly. Derivatization during sampling is required in order to prevent interfering reactions. Hundreds of different isocyanates are used in industry, and many more are formed during thermal degradation of PUR. Therefore, high selectivity of the analytical method is required for accurate results. The determination of isocyanates in the work environment using di-n-butylamine (DBA) as a reagent and liquid chromatography-mass spectrometric detection (LC-MS) has been demonstrated to be a robust method. The development of the method was initiated when difficulties using the “older” methods during sampling of isocyanates in complex atmo
Scope: This document specifies a method for the determination of organic isocyanates in workplace air using derivatization with di-n-butylamine (DBA) and chromatographic analysis. This document is applicable to the determination of a wide range of organic isocyanates present in both the gas phase and the particle phase in workplace atmospheres, including monofunctional isocyanates such as isocyanic acid (ICA), methyl isocyanate (MIC), ethyl isocyanate (EIC), propyl isocyanate (PIC), butyl isocyanate (BIC) and phenyl isocyanate (PhI); monomeric diisocyanates, including 1,6-hexamethylene diisocyanate (HDI), 2,4- and 2,6-toluene diisocyanate (TDI), 4,4′-methylenediphenyl diisocyanate (MDI), 1,5-naphthyl diisocyanate (NDI), isophorone diisocyanate (IPDI) and 4,4′-dicyclohexylmethane diisocyanate (H12MDI); and multifunctional isocyanates, including oligomeric, prepolymeric and polymeric forms such as biuret-, isocyanurate- and allophanate-adducts. The method covers air sampling using impingers, filters or combinations thereof, and analysis by liquid chromatography with mass spectrometric detection. The useful analytical range is approximately 2,5 ng to 500 ng of isocyanate per sample. For a nominal air sample volume of 15 l, this corresponds to approximately 0,2 µg/m3 to 33 µg/m3. These values can vary depending on the isocyanate analysed. This document does not apply to the determination of amines or aminoisocyanates. For the determination of amines and aminoisocyanates, the method specified in ISO 17734-2[11].