ISO 17744-2025 PDF

ISO 17744-2025 PDF

Plastics-Determination of specific volume as a function of temperature and pressure, pvT diagram-Piston apparatus method

$71.50 $143.00 -50%
Product Code: ISO 17744
Stock In Stock
Edition: 2.
Published: 05/2025
Number of Pages: 26
File Size: 1 file, 1 Byte

Available Options

Product Description

Plastics — Determination of specific volume as a function of temperature and pressure, pvT diagram — Piston apparatus method

Introduction: The characterization of changes in specific volume of plastics, as a function of temperature and pressure, is necessary for the purpose of simulation studies and for optimizing polymer processing. These thermophysical data can be used as they are or modelled in the form of suitable mathematical laws (see References [7] to [12]). In injection moulding, during the packing phase, most of the flow results from solidification. During solidification, if the plastic is semi-crystalline, the shrinkage is primarily due to crystallization. For materials with high shrinkage and fast cooling rates, material can lose wall contact especially at low holding pressures. pvT data are used to model the volumetric shrinkage, which is translated into dimensional changes in the moulding. Also, critical stress areas are detectable with a loss of wall contact. All the techniques described hereafter are equivalent in their ability to characterize the melt state pvT behaviour, the isobaric cooling measurement is the only one which allows characterization of both the supercooling behaviour and the pressure dependency of the transition. © ISO 2025 – All rights reserved

Scope: This document describes procedures for determining the specific volume of plastics as a function of temperature and pressure in both the molten and solid states. This document specifies the use of a piston-equipped apparatus in which the test sample, held in a measurement cell, is pressurized by means of the piston. Measurements under conditions of constant pressure or constant temperature can be made. NOTE For the acquisition of data needed for processing design, the isobaric cooling method is found to be more useful, see ISO 17282. The result of this measurement cannot be used directly for injection-moulding simulation. This document is used to obtain: — pvT diagrams that represent the relationship which exists between pressure, specific volume and temperature for a given material; — volumetric compressibility and volumetric thermal-expansion coefficients; — information on first-order and glass transitions as a function of temperature and pressure.

Be the first to write a review for this product.

Write a review

Note: HTML is not translated!
Bad           Good
ISO 17744-2025 PDF

ISO 17744-2025 PDF

$71.50 $143.00