Peintures et vernis - Lignes directrices pour la production de rayures au travers du revêtement de panneaux métalliques en vue des essais de corrosion
Introduction: Many International Standards deal with corrosion testing, where scribe marks are introduced through a coating to a metallic substrate. However, the method of scribe-mark introduction (scribing pattern, tools, etc.) is not standardized across these standards. The main purposes of an intentionally inflicted damage in a coating prior to corrosion testing are as follows: a) to simulate and to investigate how adhesion of a coating originating from an artificial damage after exposure is ensured; b) to obtain an accelerated response during a corrosion test, e.g. at quality control during production; c) to investigate the general durability of a coating by observation of the rate of corrosion at a damage spread after exposure. Preliminary investigations have shown that several variants, both in terms of shape and dimensions, of scribing tools are used. These variations occur both across countries and within countries. The effect of using different tools is the production of scribe marks with different cross-sectional shape, depth and exposed metal area. These differences will greatly affect test results obtained during corrosion tests, as the intention of introducing scribe marks into a coating system is such that oxygen and the electrolyte present during exposure testing can obtain access to a well-defined and active metal surface. The actual method used to introduce a scribe mark depends on the coating type and thickness. However, in all cases it is preferable if the cross-section
Scope: This document describes methods of scribing coated steel or test-pieces for corrosion tests, where the coating system is applied at dry film thicknesses of less than 500 μm. It is intended as a guideline only, being based on the results of a collaborative trial with no subsequent corrosion testing having been carried out to determine the suitability of the introduced scribe marks for such tests. This document covers the scribing of metallic panels or test pieces (chemically treated or not) made from: — steel; — galvanized steel; — aluminium alloys; — magnesium alloys. It does not cover the scribing of electroplated metal or clad aluminium panels.