Gas cylinders - Self-closing cylinder valves - Specification and type testing
Introduction: This document covers the function of a self-closing cylinder valve as a closure (defined by the UN Model Regulations). Additional features of self-closing cylinder valves (e.g. pressure relief devices) might be covered by other standards and/or regulations. Self-closing cylinder valves conforming to this document can be expected to perform satisfactorily under normal service conditions. This document pays particular attention to: a) suitability of materials; b) safety (mechanical strength, impact strength, endurance, leak tightness, resistance to ignition, resistance to acetylene flashback); c) testing; d) marking; e) manufacturing tests and examinations. In this document, the unit bar is used due to its universal use in the field of technical gases. It should, however, be noted that bar is not an SI unit, and that the corresponding SI unit for pressure is Pa (1 bar = 105 Pa = 105 N/m2). Pressure values in this document are given as gauge pressure (pressure exceeding atmospheric pressure) unless noted otherwise. © ISO 2017 – All rights reserved
Scope: This document specifies the design, type testing, marking and manufacturing tests and examinations requirements for self-closing cylinder valves intended to be fitted to refillable transportable gas cylinders which convey compressed, liquefied or dissolved gases. NOTE 1 The main applications for such self-closing cylinder valves are in the calibration gas and beverage industries. This document covers the function of a self-closing cylinder valve as a closure. NOTE 2 Requirements for standard cylinder valves are given in ISO 10297. Requirements for quick-release cylinder valves are given in ISO 17871. This document is not applicable to self-closing cylinder valves for cryogenic equipment, for portable fire extinguishers, or for liquefied petroleum gas (LPG). NOTE 3 Requirements for valves for cryogenic vessels are specified in ISO 21011 and at a regional level, for example, in EN 1626. Requirements for valves for portable fire extinguishers at a regional level are specified, for example, in EN 3 series. Requirements for self-closing LPG cylinder valves are specified in ISO 14245. NOTE 4 Additional requirements for pressure-relief devices might be specified in international/regional regulations/standards.