Plastiques - Détermination des caractéristiques au choc Charpy - Partie 1: Essai de choc non instrumenté
Introduction: The Charpy impact properties determination method described in the ISO 179 series has a greater range of applicability than that given in ISO 180 and is more suitable for the testing of materials showing interlaminar shear fracture or of materials exhibiting surface effects due to environmental factors. The method is suitable for use with the following range of materials: — rigid thermoplastic moulding and extrusion materials (including filled and reinforced compounds in addition to unfilled types) and rigid thermoplastics sheets; — rigid thermosetting moulding materials (including filled and reinforced compounds) and rigid thermosetting sheets (including laminates); — fibre-reinforced thermosetting and thermoplastic composites incorporating unidirectional or multi- directional reinforcements (such as mats, woven fabrics, woven rovings, chopped strands, combination and hybrid reinforcements, rovings and milled fibres) or incorporating sheets made from pre-impregnated materials (prepregs), including filled and reinforced compounds; — thermotropic liquid-crystal polymers. Notched samples are not normally suitable for use with rigid cellular materials, long-fibre-reinforced composites or thermotropic liquid-crystal polymers. In these cases, unnotched samples may be used. The method is suited to the use of specimens moulded to the chosen dimensions, machined from the central portion of a standard multipurpose test specimen (see ISO 20753) or machined from finished or semi- finish
Scope: This document specifies a method for determining the Charpy impact strength of plastics under defined conditions. It defines a number of different types of specimen and test configurations. It also specifies different test parameters according to the type of material, the type of test specimen and the type of notch. The method described in this document can be used to investigate the behaviour of specified types of specimen under the impact conditions defined and for estimating the brittleness or toughness of specimens within the limitations inherent in the test conditions. It can also be used for the determination of comparative data from similar types of material.