Rolling bearings — Method for calculating the effective static safety factor for universally loaded rolling bearings
Introduction: ISO 76 specifies a simplified method for the calculation of static safety factor of rolling bearings. However, this method cannot account for actual operating conditions like tilt, misalignment, moment load or for operating clearance. The calculation method specified in this document is based on the detailed analysis of bearing internal load distribution, as described in ISO 16281[1]. It uses maximum ball or lamina loads for the calculation of the effective static safety factor, thus following the general principle of ISO 76. The calculation method yields no satisfactory results for rolling bearings subjected to considerable truncation of the area of contact between the rolling elements and the raceway. The primary purpose of this document is to provide a unified and manufacturer-independent advanced calculation method that allows for the consideration of actual operating conditions, thus enabling the end user to compare different bearing solutions on the same calculation basis. It is also intended to serve as a manufacturer-independent neutral basis for certification purposes, for example, as required per IEC 61400-4[2] for bearings in wind turbine gearboxes. It is not intended to supersede other advanced bearing analysis methods that are currently used in the design process as the primary tool for bearing design and selection. The static load rating according to ISO 76 was originally based on a permanent plastic deformation under static load, i.e. a constant load on a non-r
Scope: This document specifies the calculation of the effective static safety factor under consideration of tilt or misalignment, operating clearance of the bearing, and internal load distribution on rolling elements. The calculation method provided in this document covers influencing parameters in addition to those described in ISO 76. The directions and limitations given in ISO 76 and ISO 20056-2 apply to this document. The calculation method pertains to the static safety factor of the bearings. Other mechanisms of failure, like false brinelling, fatigue life, wear or microspalling (gray-staining), lie outside the scope of this document. This document applies to single and multi-row radial and thrust ball and roller bearings, subjected to radial and axial load and with radial clearance and tilt taken into account. References to methods for the analysis of the internal load distribution under general load are given. The analysis of effective static safety factor for multi-row bearings or bearings of a more complex geometry can be derived from the formulae given in this document. For these bearings, the load distribution for each individual row is considered. The calculation of effective static safety factor is also applicable to hybrid bearings, using the static load ratings according to ISO 20056-2.