ISO 17987-4-2025 PDF

ISO 17987-4-2025 PDF

Road vehicles-Local Interconnect Network (LIN)-Part 4: Electrical physical layer (EPL) specification 12 V/24 V

$129.00 $258.00 -50%
Product Code: ISO 17987-4
Stock In Stock
Edition: 2.
Published: 06/2025
Number of Pages: 50
File Size: 1 file, 4 Bytes

Available Options

Product Description

Road vehicles — Local Interconnect Network (LIN) — Part 4: Electrical physical layer (EPL) specification 12 V/24 V

Introduction: The LIN protocol as proposed is an automotive focused low speed universal asynchronous receiver transmitter (UART) based network. Some of the key characteristics of the LIN protocol are signal-based communication, schedule table-based frame transfer, commander/responder communication with error detection, node configuration and diagnostic service transportation. The LIN protocol is for low-cost automotive control applications as, for example, door module and air conditioning systems. It serves as a communication infrastructure for low-speed control applications in vehicles by providing: — signal-based communication to exchange information between applications in different nodes; — bit rate support from 1 kbit/s to 20 kbit/s; — deterministic schedule table-based frame communication; — network management that wakes up and puts the LIN cluster into sleep state in a controlled manner; — status management that provides error handling and error signalling; — transport layer that allows large amount of data to be transported (such as diagnostic services); — specification of how to handle diagnostic services; — electrical physical layer specifications; — node description language describing properties of responder nodes; — network description file describing behaviour of communication; — application programming interface. The ISO 17987 series is based on the open systems interconnection (OSI) basic reference model as specified in ISO/IEC 7498-1 which structures communication systems

Scope: This document specifies the 12 V and 24 V electrical physical layers (EPL) of the LIN communications system. The electrical physical layer for LIN is designed for low-cost networks with bit rates up to 20 kbit/s to connect automotive electronic control units (ECUs). The medium that is used is a single wire for each receiver and transmitter with reference to ground. Annex A provides recommendations on the LIN physical layer peripheral interface design of type UART and frame controller for commander and responder nodes. This document includes the definition of electrical characteristics of the transmission itself and also the documentation of basic functionality for bus driver devices. This document also provides the physical layer definitions for nodes with LIN AA capabilities according to one of the procedures C, D and E. All parameters in this document are defined for the ambient temperature range from −40 °C to 125 °C.

Be the first to write a review for this product.

Write a review

Note: HTML is not translated!
Bad           Good
ISO 17987-4-2025 PDF

ISO 17987-4-2025 PDF

$129.00 $258.00