Timber structures - Test methods - Floor vibration performance
Introduction: Dynamic properties of timber structures are of critical importance to designers since they govern how these structures respond to seismic, wind and in-service human-induced dynamic excitation. Seismic and wind can cause structural failure, while in-service human-induced motion generally causes serviceability problems related to human discomfort; this is also true to wind-induced building motion. Since occupants are constantly in contact with the floor system, vibration serviceability of floor systems is often of concern to designers of timber structures. Vibrational performance of a timber floor can be assessed using parameters such as natural frequencies, damping ratios, dynamic responses to an impulse (dynamic displacement, velocity, and acceleration), and static deflection under a concentrated load. These parameters have been found to correlate well with human perceptions. Among these parameters, natural frequencies, damping ratios, and static deflection under concentrated load are commonly used to evaluate timber floor vibrational performance. Design procedures have been developed, and in some cases implemented in design standards, for assessing vibration serviceability of timber floors. These design procedures usually include criteria for floor response parameters, such as those listed above, and mathematical procedures to calculate these parameters. As an alternative to calculation, it is also necessary to provide standardized procedures to measure these parameters expe
Scope: This International Standard specifies test procedures to measure natural frequencies, modal damping ratios and static deflection under a concentrated load of laboratory or field timber floors. These parameters have been found to correlate well with human perception to timber floor vibration response caused by human-induced excitation under normal use. It is intended that the test procedures can be applied in lieu of calculation to quantify some or all of the above parameters that are used to evaluate the vibrational serviceability of the test floor. The subsequent use of the measured parameters to evaluate vibrational serviceability is, however, outside the scope of this International Standard. ISO published a series of International Standards on the application of modal testing and analysis to determine natural frequencies, modal damping ratios, and other dynamic properties of a structure. For the measurement of dynamic parameters such as natural frequencies and modal damping ratios, modal testing is proposed in this International Standard. It is assumed that the test operators possess the required equipment and fundamental knowledge to perform such a test. The theory of modal testing and analysis has been well documented in Reference [4].