Method for the assessment of the degree of pigment or carbon black dispersion in polyolefin pipes, fittings and compounds
Introduction: Thermoplastic products manufactured for pipeline systems are normally pigmented. Typically, fine carbon black particles or pigments are used. These are normally incorporated into the raw material prior to either extrusion of pipe or injection moulding of pipe fittings. The purpose of colouring is to allow identification of the pipeline in service and, in the case of carbon black, to act as protection of the polymer from degradation by ultra-violet light if the product is stored outdoor or used for outdoor service. It is important that the carbon black or pigment particles are correctly dispersed in the polymer, and hence the final product, to ensure that the physical, mechanical and surface protection properties are maintained. Correct dispersion can also be an indication that antioxidants and ultra-violet stabilizers are correctly dispersed, and that the size of agglomerates or particles is not excessive. This method provides procedures for assessing the degree of dispersion by physical measurement of the size of the dispersed particles and arithmetic grading of the particle size distribution. It also provides photographs for comparison with microscopic images of samples taken from raw-material compounds or products in order to judge subjectively the acceptability of carbon black or pigment dispersion. A recommended limit of particles/agglomerate size grading and an acceptable rating of appearance is given in Annex D. © ISO 2025 – All rights reserved
Scope: This document describes a method with two procedures for the assessment of carbon black or pigment particle and agglomerate size, and the rating of dispersion in polyolefin pipes, fittings and compounds. The method is applicable to polyolefin pipes and fittings, as well as raw material in pellet form, with the choice of procedure to be determined by the referring specification. The method is applicable to carbon black or pigmented polyolefin pipes, fittings and compounds with a carbon black content of less than 3 % by weight, and pigment content of less than 5 % by weight.