Machinery for forestry - Noise test code
Introduction: This International Standard is a specific noise test code for forestry machinery mentioned in the scope of this International Standard and as defined in ISO 6814. A simulated dynamic test condition, rather than an actual work cycle, is used. Simulated dynamic test conditions provide noise emission data which are repeatable and representative. Actual work cycle tests are complex and repeatability can be a problem. This International Standard may also be used to determine noise emission for each part of the simulated work cycle. Specific procedures are described in this International Standard to enable the sound power level and the emission sound pressure level in dynamic test conditions to be determined in a manner which is repeatable. This International Standard enables compliance with noise limits to be determined, if applicable. It can also be used for evaluation purposes in noise reduction investigations. © ISO 2016 – All rights reserved
Scope: This noise test code specifies all the information necessary for carrying out efficiently and under standardised conditions the noise emission values of self-propelled forestry machinery. It is applicable to fellers, bunchers, delimbers, forwarders, log loaders, skidders, processors, harvesters, mulchers and multi-function versions of these machine types, as defined in ISO 6814. Noise emission characteristics include A-weighted emission sound pressure values at the operator’s station and the A-weighted sound power value. The determination of these quantities is necessary for the following: — manufacturers to declare the noise emitted; — comparing the noise emitted by machines in the family concerned; — purposes of noise control at the source at the design stage. NOTE For low-noise design, noise emission values in frequency bands are useful and the basic International Standards ISO 3744 and ISO 11201 can be used for determining noise emission quantities in frequency bands.