Imaging materials — Scratch resistance of photographic prints — Part 2: Sclerometer test method
Introduction: This method is one of a series ISO 189xx relating to permanence and durability of image prints, which is their resistance to mechanical, chemical and/or environmental stresses in conditions of use. The permanence of the image under environmental stresses is tested by each stress factor individually: light (ISO 18937[6]), heat (ISO 18936[5]), ozone (ISO 18941[7]), and humidity (ISO 18946[8]). These stress factors are given by the ambient conditions, over which the user often has limited control. The exposure to mechanical and physical stress may often be controlled by the user, unless intense handling is integral to intended use. Tests for rubbing of prints resulting in abrasion or smearing of the image are handled in ISO 18947-1[9] and ISO 18947-2[10], scratch resistance (of film) is addressed in ISO 18922[3] and durability tests to simulate accidental exposure to water are described ISO 18935[4]. Photographic prints are also susceptible to scratching when handled. This problem is particularly evident with digital prints, which may be composed of various layers and may include colorants on the surface that are not protected from physical damage. Test methods for evaluating the scratch resistance of photographic prints are another means to characterise the physical durability of photographic prints. This document provides standardized requirements to evaluate the scratch resistance of image prints in their various formats. Scratch might occur accidentally or repeatedly by hand
Scope: This document specifies test parameters, test procedures, test targets, and reporting requirements for determining the scratch resistance of photographic prints using the sclerometer test method. It is applicable to photographic prints that have no protection as well as photographic prints that are protected by a coating or lamination. It is specifically useful as a low-cost, easily implemented procedure for evaluating scratch resistance of these prints. It is not the purpose of this document to define limits of acceptability or failure. Limits would be determined by the user and the intended application.