ISO 19064-1-2015 PDF

ISO 19064-1-2015 PDF

Plastics - Styrene/acrylonitrile (SAN) moulding and extrusion materials - Part 1: Designation system and basis for specifications

$31.50 $63.00 -50%
Product Code: ISO 19064-1
Stock In Stock
Edition: 1ST
Published: 11/15/2015
Number of Pages: 14
File Size: 1 file, 291 Bytes

Available Options

Product Description

Plastics - Styrene/acrylonitrile (SAN) moulding and extrusion materials - Part 1: Designation system and basis for specifications

Introduction: ISO 4894-1:1997 is complex and does not fit with daily practice anymore. In practice the ISO 1043–series and ISO 11469 are, in combination, ‘improperly’ being used as a designation system for e.g. marking. The aim of this International Standard is to simplify the data block system and to connect more to the ISO 1043–series and ISO 11469, where the first two blocks are used for generic identification and marking of products. © ISO 2015 – All rights reserved

Scope: This part of ISO 19064 establishes a system of designation for styrene/acrylonitrile (SAN) moulding and extrusion materials, which may be used as the basis for specifications. The types of styrene/acrylonitrile plastic are differentiated from each other by a classification system based on appropriate levels of the designatory properties, a) Vicat softening temperature, b) melt mass-flow rate, and on information about composition, intended application and/or method of processing, important properties, additives, colorants, fillers and reinforcing materials. This part of ISO 19064 is applicable to all copolymers of styrene and/or substituted styrene having between 5 % (m/m) and 50 % (m/m) acrylonitrile. It applies to materials ready for normal use, unmodified or modified by colorants, additives, fillers, etc. This part of ISO 19064 does not apply to expandable materials. It is not intended to imply that materials having the same designation give necessarily the same performance. This part of ISO 19064 does not provide engineering data, performance data or data on processing conditions which may be required to specify a material for a particular application and/or method of processing. If such additional properties are required, they shall be determined in accordance with the test methods specified in ISO 4894-2, if suitable. In order to specify a thermoplastic material for a particular application or to ensure reproducible processing, additional requirements may be given in data block 5 (see 3.1).

Be the first to write a review for this product.

Write a review

Note: HTML is not translated!
Bad           Good
ISO 19064-1-2015 PDF

ISO 19064-1-2015 PDF

$31.50 $63.00