ISO 19066-1-2014 PDF

ISO 19066-1-2014 PDF

Plastics - Methyl methacrylateacrylonitrile- butadiene-styrene (MABS) moulding and extrusion materials - Part 1: Designation system and basis for specifications

$48.00 $96.00 -50%
Product Code: ISO 19066-1
Stock In Stock
Edition: 1ST
Published: 10/01/2014
Number of Pages: 14
File Size: 1 file, 474 Bytes

Available Options

Product Description

Plastics - Methyl methacrylateacrylonitrile- butadiene-styrene (MABS) moulding and extrusion materials - Part 1: Designation system and basis for specifications

Introduction: ISO 10366-1:2002 is complex and does not fit with daily practice anymore. In practice ISO 1043 and ISO 11469 are, in combination, ‘improperly’ being used as a designation system for, e.g. marking. The aim of this International Standard is to simplify the data block system and to connect more to ISO 1043 and ISO 11469, where the first two blocks are used for generic identification and marking of products. © ISO 2014 – All rights reserved

Scope: This part of ISO 19066 establishes a system of designation for methyl methacrylate-acrylonitrile- butadiene-styrene (MABS) moulding and extrusion materials, which can be used as the basis for specifications. The types of MABS plastic are differentiated from each other by a classification system based on appropriate levels of the designatory properties a) Vicat softening temperature, b) melt volume-flow rate, c) Charpy notched impact strength, and d) tensile modulus, and on information about composition, intended application and/or method of processing, important properties, additives, colorants, fillers, and reinforcing materials. This part of ISO 19066 is applicable to all methyl methacrylate-acrylonitrile-butadiene-styrene materials consisting of a continuous phase based mainly on copolymers of styrene (and/or an alkyl-substituted styrene), acrylonitrile and methyl methacrylate, and a dispersed elastomeric phase based on butadiene. It applies to MABS materials ready for normal use in the form of powder, granules, or pellets, unmodified or modified by colorants, additives, fillers, etc. It is not intended to imply that materials having the same designation give necessarily the same performance. This part of ISO 19066 does not provide engineering data, performance data, or data on processing conditions which might be required to specify a material for a particular application and/or method of processing. If such additional properties are required, they will be determined in accordance with the test methods specified in ISO 10366-2, if suitable. In order to specify a thermoplastic material for a particular application or to ensure reproducible processing, additional requirements can be given in data block 5 (see 3.1).

Contents:

  • Foreword
  • Introduction
  • Scope

Be the first to write a review for this product.

Write a review

Note: HTML is not translated!
Bad           Good
ISO 19066-1-2014 PDF

ISO 19066-1-2014 PDF

$48.00 $96.00