Implants for surgery - Test methods of material for use as a cortical bone model
Introduction: This document details requirements for a set of mechanical test methods to evaluate material used as a cortical bone model. Bone models have long been used in mechanical tests for devices or instruments such as those used in the orthopaedic surgery. The characteristics of the bone model, especially those of a cortical bone model, strongly influence the test results. Many devices and instruments are evaluated using bone models. Newer bone models are needed because conventional bone model properties change the primary outcome of interest such as failure mode. This results in devices not being evaluated correctly. Animal bones such as those from pigs are still used. However, animal bones have many sanitary problems and can introduce large errors (standard deviation). Recently, several new bone models have been introduced and standardized methods for evaluating these materials are required. This document introduces applicable standardized mechanical test methods for characterizing the material properties of cortical bone models. The mechanical properties of the cortical bone itself such as tensile strength and compressive strength have been measured for some time, and several models have been produced based on the results. However, these fundamental mechanical properties do not strictly conform to the tactile feedback experienced by physicians. Material models have differences in tensile, compressive and shear strengths properties since they do not reproduce the complex anisotrop
Scope: This document specifies mechanical test methods for characterizing cortical bone model materials for use as a standard model for performing mechanical tests for devices or instruments used in orthopaedic surgery, plastic surgery, neurosurgery, and oral and maxillofacial surgery. The document specifies static mechanical test and properties. Dynamic and viscoelastic/poroelastic tests and properties are not included in the scope of this document.