Gas analysis — Sampling guidelines
Introduction: The determination of gas composition, impurity concentration and physical properties depend, to a large extent, on sampling technique. The use of correct sampling techniques is an important safety and quality critical step in gas analysis. The design, construction and selection of the sampling equipment to avoid hazardous situations and sampling errors are important and directly influence the results obtained. Any slight carelessness, inexactitude or mistake will seriously influence safety and the results obtained. Gaseous products are stored and transported in pressure receptacles in the form of compressed or liquefied gas or through gas pipelines. The sampling methods used differ depending upon the package, composition and delivery methods. This document provides technical guidelines for the sampling of gases in pressure receptacles and pipelines for analytical purposes. vi © ISO 2020 – All rights reserved
Scope: This document specifies the general provisions and gives the basic definitions of terms relating to sampling for gas analysis, including sampling devices, sampling methods, sampling technical considerations, and sampling safety. This document applies to both direct and indirect sampling of gas in pressure receptacles and pipelines, including pure gases and gas mixtures. Compressed and liquefied gases are both considered. This document applies to the sampling of processed gases and does not involve gas treatment processes. The sampling procedures specified are not intended for the sampling of special products which are the subject of other International Standards, such as liquefied petroleum gases (see ISO 4257) and gaseous natural gases (see ISO 10715).