Petroleum and natural gas industry — Pipeline transportation systems — Pipeline integrity management specification — Part 1: Full-life cycle integrity management for onshore pipeline
Introduction: This document addresses the integrity of petroleum and natural gas pipelines through their entire life-cycle, from design to eventual abandonment. For this reason, considerations relating to design, construction and abandonment have been included. This approach supports the development and implementation of a holistic and integrated pipeline integrity management program that bridges between life-cycle elements and thereby avoids compartmentalizing of the pipeline life-cycle into essentially independent data and functional silos, which traditionally has been the case. The integrated approach was developed on the basis of extensive research and examination of best practices and results from pipeline integrity audits world-wide. This document incorporates a combination of prescriptive and performance-based requirements. In some cases where there are prescription requirements, it provides the user the option to arrive at a solution using performance- based requirements. However, the level of safety achieved by following the prescriptive requirements gives the minimum performance-based requirements. The ability to use performance-based solutions allows companies to use new equipment or innovative practices to achieve the same goal. This document is intended to be used by companies that have not yet developed an official program or are developing a program for new pipelines. This document can also be used for continual improvement of existing programs by both operating companies an
Scope: 1.1 This document specifies requirements and gives recommendations on the management of integrity of a pipeline system throughout its life cycle which includes design, construction, commissioning, operation, maintenance and abandonment. 1.2 This document is applicable to onshore pipeline systems used in transportation in the petroleum and natural gas industries, connecting wells, production plants, process plants, refineries and storage facilities, including any section of a pipeline constructed within the boundaries of such facilities for connection purposes. The extent of pipeline systems covered by this document is illustrated in Figure 1. This document does not deal specifically with the integrity of non-pipe elements. The pipeline segment between the wellsite and the gathering station, treatment plant or process plant (between Facilities 1 and 2 in Figure 1) is included in this document, though many mandatory elements of this document are not practical due to characteristics such as diameter, operating parameters, etc. 1.3 This document applies to rigid, steel pipelines. It is not applicable for flexible pipelines or those constructed from other materials, such as glass-reinforced plastics. 1.4 This document does not cover all conditions nor engineers’ competency which might be related to pipeline integrity. The user can evaluate whether additional requirements are necessary. 1.5 This document is used for integrity management, which is initiated at the design and construction stage of the pipeline. Where requirements of a design and construction standard (e.g. ISO 13623) are INTERNATIONAL STANDARD ISO 19345-1:2019(E) © ISO 2019 – All rights reserved ISO 19345-1:2019(E) different, the provisions of this document will enhance the design and construction from an integrity perspective. Key wellsite pump station depot gathering station, treatment valve station distribution plant or process plant tankage compressor station liquid refinery pressure-reduction station gas pipeline elements covered by this document connections with other facilities pipeline elements not covered by this document station/plant area covered by this document Figure 1 — Extent of pipeli