ISO 19375-2024 PDF

ISO 19375-2024 PDF

Fibre-reinforced composites-Measurement of interfacial shear strength by means of a micromechanical single-fibre pull-out test

$129.00 $258.00 -50%
Product Code: ISO 19375
Stock In Stock
Edition: 1.
Published: 11/2024
Number of Pages: 52
File Size: 1 file, 5 Bytes

Available Options

Product Description

Fibre-reinforced composites — Measurement of interfacial shear strength by means of a micromechanical single-fibre pull-out test

Introduction: Fibre-reinforced composites have become an indispensable part of modern high-tech applications due to the excellent tensile properties of the reinforcement fibres incorporated in the composite. This requires that the loads in a composite need to be distributed evenly to all fibres by means of a matrix. Therefore, a high interfacial shear strength is required for a good load transfer. Hence, the interfacial shear strength is one of the key parameters in composite technology. To characterize the interfacial shear strength, composites with unidirectional aligned fibres are manufactured. A tensile test is then performed perpendicular to the fibre orientation (transverse tensile test), or a short beam shear strength test (as defined for instance in ISO 14130 or ASTM D2344) is performed to measure the apparent interlaminary shear strength (ILSS). However, the maximum stress found in such macromechanical tests does not only depend on the fibre-matrix adhesion strength, it is also governed by the following additional factors: the fibre content, orientation, length, diameter and fibre distribution homogeneity, the pore void of the test specimens, and the mechanical properties of the fibre and the matrix. To achieve repeatable results for the fibre-matrix adhesion strength through macromechanical tests, it is necessary to keep a rigid control of the manufacturing process of the specimen, making the overall testing procedure laborious and difficult to compare across laboratories. Microm

Scope: This document specifies a test method for determining the interfacial shear strength between a single fibre and a matrix by means of a pull-out test. The method can be used to measure the critical energy release rate. The method is applicable to reinforcement fibres, such as carbon fibres, glass fibres, basalt fibres and similar stiff reinforcement fibres and to thermoset, thermoplastic and fine-grained concrete matrices. It can be used for polymeric reinforcement fibres and for other inorganic matrices. It is not applicable to: a) elastomeric fibres and elastomeric matrices such as rubber; b) matrices which cure or melt at temperatures above 400 °C; c) matrices that show a strong tendency to bubble formation or expansion during the sample-preparation process; d) foams.

Be the first to write a review for this product.

Write a review

Note: HTML is not translated!
Bad           Good
ISO 19375-2024 PDF

ISO 19375-2024 PDF

$129.00 $258.00