ISO 19606-2024 PDF

ISO 19606-2024 PDF

Fine ceramics (advanced ceramics, advanced technical ceramics)-Test method for surface roughness of fine ceramic films by atomic force microscopy

$96.50 $193.00 -50%
Product Code: ISO 19606
Stock In Stock
Edition: 2.
Published: 11/2024
Number of Pages: 32
File Size: 1 file, 2 Bytes

Available Options

Product Description

Fine ceramics (advanced ceramics, advanced technical ceramics) — Test method for surface roughness of fine ceramic films by atomic force microscopy

Introduction: Surface roughness measurements of fine ceramic thin films at the nanometre scale by atomic force microscopy is widely applied to quality control and assurance in industries. One frequently occurring issue in roughness measurements by atomic force microscopy resulting from its scale dependency is the deviation of roughness due to wear of the probe tip or the deviation in the curvature of commercially available probe tips. This makes it difficult to obtain a reliable and reproducible result of the roughness measurement. Therefore, it is highly desirable to standardize a method to evaluate probe tip diameter or curvature radius. This document covers the evaluation of probe-tip diameter and provides a method to judge the adequateness of a probe tip for use in day-to-day roughness measurements of fine ceramic thin films with a certain arithmetical mean roughness in the range needing the use of atomic force microscopy in production lines or quality assurance processes. It should be noted that because surface roughness is a scale-dependent metrology parameter, it is unavoidable that the probe-tip evaluation process contains some contradictory procedures, namely the adequateness of the probe tip for a roughness measurement depends on unmeasurable true roughness in a scale of interest. In this document, the parameters based on roughness profiles are used. The roughness profile is obtained by using a low-pass filter according to ISO 16610-21. The process to obtain the sampling length,

Scope: This document specifies a method to evaluate the adequateness of a probe tip for fine-ceramic thin-film surface roughness measurements by atomic force microscopy. This method applies to surfaces with an arithmetical mean roughness, Ra, in the range of about 1 nm to 30 nm and a mean width of roughness profile elements, Rsm, in the range of about 0,04 μm to 2,5 μm.

Be the first to write a review for this product.

Write a review

Note: HTML is not translated!
Bad           Good
ISO 19606-2024 PDF

ISO 19606-2024 PDF

$96.50 $193.00