Additive manufacturing — Non-destructive testing and evaluation — Guideline for dimensional measurements based on cone beam X-ray Computed Tomography
Introduction: X-ray Computed Tomography (XCT) is used for many aspects of quality control of parts in the industry, i.e. three-dimensional (3D) visualisation in volume for function testing, Non-Destructive Testing (NDT) or Non- Destructive Evaluation (NDE) for flaw analysis, but also metrology for nominal/actual comparison, tolerance analysis, and dimensional measurements.[1,2] This increased adoption can be explained by the fact that additive manufacturing (AM), producing parts with complex geometries that can contain internal features, is becoming increasingly popular in the industry. Parts conventionally manufactured without internal features, are dimensionally measured by surface methods, providing a 3D surface point cloud (discrete set of data points in space) obtained, for example, using a coordinate measuring machine (CMM). However, surface methods, for complex geometries with internal features, are no longer appropriate. Therefore, XCT, a 3D volumetric non-destructive testing method, capable of adapting to complex geometric shapes and rough surfaces, providing the visualisation of the whole volume of a test part (geometric 3D representation of the inside and outside) is required for AM to perform internal dimensional measurements. Performing dimensional measurements on a 3D volumetric XCT data is a complex process as XCT is a complex process involving several steps: 1) specifying rigorously, with the customer, the measurands of interest in the test part in a defined coordinate syst
Scope: This document specifies requirements and recommendations to be followed prior to carrying out dimensional measurements on three-dimensional (3D) volumetric X-ray Computed Tomographic (XCT) data of additive manufacturing (AM) series production parts. It is applicable to cone beam XCT systems. However, these requirements and recommendations can be transposed to non-medical fan beam XCT systems, but they are limited to standard XCT trajectories (circular and helical) and standard reconstructions. The proposed methodology in this document is restricted to the qualification and validation of an XCT system prior to proceeding to dimensional measurements on specific AM series production parts and cannot be generalised to any application. This document provides a method to evaluate XCT dimensional measurement accuracy. However, it does not claim to provide a definitive method, given the complexity of an XCT process. For the same reason, it is addressed to qualified XCT operators with the support of metrology experts. This document is dedicated to AM series production parts and its aim is to provide a methodology for controlling the geometric specificities associated with AM (internal shapes, lattice structures). It is applicable on parts that are fabricated by any type of AM categories of processes and material provided the X-ray penetration lengths are sufficient to scan the test part.