Identification cards - Recording technique - Part 8: Magnetic stripe — Coercivity of 51,7 kA/m (650 Oe)
Introduction: This part of ISO/IEC 7811 is similar to ISO/IEC 7811-2, except that its higher coercivity requires higher energy to encode the data. The user of ISO/IEC 7811-8 is encouraged to review the entire standard for revisions and updates. The major differences from ISO/IEC 7811-2 are listed below. — In terms of coercivity, this part of ISO/IEC 7811 media (51,7 kA/m, 650 Oe) is between ISO/IEC 7811- 2 (23,9 kA/m, 300 Oe) and ISO/IEC 7811-6 (minimum 199 kA/m, 2 500 Oe). — The primary application for 51,7 kA/m (650 Oe) is for hotel guest room entry systems worldwide. — For Table 1 values, this part of ISO/IEC 7811 specifies different values for Imin (6,5 FR) and Imax (8 FR). — Encoding techniques, specification, and error detection are not specified in this part of ISO/IEC 7811. — Wherever possible, the same definitions, criteria, and test methods are used in ISO/IEC 7811-2, ISO/IEC 7811-6, and this part of ISO/IEC 7811. Notes in this part of ISO/IEC 7811 are only used for giving additional information intended to assist understanding or use, and do not contain provisions or requirements to which it is necessary to conform in order to be able to claim compliance with this part of ISO/IEC 7811. © ISO/IEC 2014 – All rights reserved
Scope: This International Standard defines the characteristics for identification cards as defined in Clause 4 of this part of ISO/IEC 7811, and the use of such cards for international interchange. This part of ISO/IEC 7811 specifies requirements for a 51,7 kA/m (650 Oe) magnetic stripe (including any protective overlay) on an identification card. The encoding technique and coded character sets are not defined, however, the specifications of ISO/IEC 7811-2 may be used. It takes into consideration both human and machine aspects and states minimum requirements. Coercivity influences many of the quantities specified in this part of ISO/IEC 7811. It has a nominal value of 51,7 kA/m (650 Oe), but is not itself specified. Exposure of the card to a magnetic field is likely to destroy the recorded data. This International Standard provides criteria to which cards are to perform. No consideration is given within this International Standard to the amount of use, if any, experienced by the card prior to test. Failure to conform to specified criteria is negotiated between the involved parties. ISO/IEC 10373-2 specifies the test procedures used to check cards against the parameters specified in this part of ISO/IEC 7811. Numeric values in the SI and/or Imperial measurement system in this part of ISO/IEC 7811 may have been rounded off and therefore are consistent with, but not exactly equal to, each other. Either system may be used, but the two are not to be intermixed or reconverted. The original design was made using the Imperial measurement system. 2 Conformance A prerequisite for conformance with this part of ISO/IEC 7811 is conformance with ISO/IEC 7810. An identification card is in conformance with this part of ISO/IEC 7811 if it meets all mandatory requirements specified herein. Default values apply if no others are specified. 3 Normative references The following documents, in whole or in part, are normatively referenced in this document and are indispensable for its application. For dated references, only the edition cited applies. For undated references, the latest edition of the referenced document (including any amendments) applies. ISO 4287, Geometrical Product Specifica