ISO/IEC DIS 29183-2025 PDF

ISO/IEC DIS 29183-2025 PDF

Information technology-Office equipment-Method for measuring digital copying productivity for a single one-sided original

$48.00 $96.00 -50%
Product Code: ISO/IEC DIS 29183
Stock In Stock
Edition: 25#
Published: 10/13/2025
Number of Pages: 36
File Size: 1 file, 3.7 MB

Available Options

Product Description

Information technology — Office equipment — Method for measuring digital copying productivity for a single one-sided original

Introduction: Many digital copying devices produce copied pages at a different rate than their nominal speed when running with different quality modes, different substrate grammage, different job content and job lengths. The degree to which a change in productivity is experienced depends significantly on other parameters of the job stream. The most dominant of the parameters of the job stream are: (image quality modes selected, job content, B&W and colour reproduction job stream, run length). The existing International Standard (ISO/IEC 24735) only addresses the productivity issues for digital copying devices when using both collation and an ADF (automatic document feeder) and cannot be used for a single one sided original. This document provides a general method for measuring productivity when the above-mentioned job stream parameters for digital copying devices are taken into consideration. This document also includes instructions for the creation of test charts. It allows manufacturers and buyers of digital copying devices to describe the productivity of various digital copying devices with respect to representative office usage. © ISO/IEC 2025 – All rights reserved

Scope: This document specifies a method for measuring productivity of digital copying devices and multifunctional devices with various copying modes and a single one-sided original. The document is applicable to digital copying devices and multifunctional devices. The document is intended to be used for black and white (B&W) as well as colour digital copying devices and multifunctional devices of any underlying marking technology. This document includes instructions for the creation of test charts, test setup procedure, test procedure, and the reporting requirements for the digital copying productivity measurements. This document is not intended to replace manufacturer's rated speeds.

Be the first to write a review for this product.

Write a review

Note: HTML is not translated!
Bad           Good
ISO/IEC DIS 29183-2025 PDF

ISO/IEC DIS 29183-2025 PDF

$48.00 $96.00