Information technology – Generic cabling for customer premises – Part 9904: Assessment and mitigation of installed balanced cabling channels to support 2,5GBASE-T and 5GBASE-T
Introduction: This document provides guidance on whether installed Class D and Class E channels specified in ISO/IEC 11801:2002 will support 2,5GBASE-T and 5GBASE-T. This document also provides mitigation procedures to improve the performance of Class D and Class E channels to the point where these applications are supported. Higher classes according to ISO/IEC 11801:2002 will support 2,5GBASE-T and 5GBASE-T without mitigation up to 100 m. The support of 2,5GBASE-T and 5GBASE-T includes additional parameters and an extended frequency range for Class D. Conformance of installed cabling beyond the original cabling specifications should be determined on a case-by-case basis, and is primarily needed due to new application requirements. Whether these requirements are met by a specific channel is influenced by the components and installation practices used. As 2,5GBASE-T and 5GBASE-T use frequencies above those specified for Class D of ISO/IEC 11801:2002 as well as exogenous noise parameters, input from supplier and installer might be helpful to evaluate the performance of installed Class D and Class E channels. This document takes into account the design goals for 2,5GBASE-T and 5GBASE-T equipment such as frequency signal range up to 100 MHz for 2,5GBASE-T and up to 250 MHz for 5GBASE-T.
Scope: This part of ISO/IEC 11801 a) specifies the transmission performance for balanced cabling channels to support 2,5GBASE-T and 5GBASE-T, b) specifies the methods to assess whether installed Class D and Class E channels meet 2,5GBASE-T and 5GBASE-T requirements, c) provides mitigation techniques to improve the performance of an existing installation to meet the 2,5GBASE-T and 5GBASE-T requirements, d) provides cabling recommendations for new installations. NOTE 1 The channel transmission performance specified in this document is derived from IEEE Std 802.3bz:2016. NOTE 2 IEEE Std 802.3bz:2016 specifies requirements beyond the frequency range specified for Class D of ISO/IEC 11801:2002 and additional parameters to those specified for Class D and Class E cabling in ISO/IEC 11801:2002. NOTE 3 This document does not re-specify Class D and Class E cabling of ISO/IEC 11801:2002.
Contents:
- FOREWORD
- INTRODUCTION
- Scope