Preparation of steel substrates before application of paints and related products — Analytical colorimetry method to support visual assessment of surface preparation grades
Introduction: The performance of protective coatings of paint and related products applied to steel is significantly affected by the state of the steel surface immediately prior to painting. The principal factors that are known to influence this performance are a) the presence of rust and mill scale, b) the presence of surface contaminants, including salts, dust, oils and greases, and c) the surface profile. The ISO 8501 series, the ISO 8502 series and the ISO 8503 series provide methods for assessing these factors, while the ISO 8504 series provides guidance on the preparation methods that are available for cleaning steel substrates, indicating the capabilities of each in attaining specified levels of cleanliness. These International Standards do not contain provisions on the protective coating systems applied to the steel surface. They do not contain provisions related to the surface quality requirements for specific situations even though surface quality can have a direct influence on the choice of protective coating applied and on its performance. Such provisions are given in other documents such as national standards and codes of practice. It would be useful for users of these International Standards to ensure that the qualities specified are — compatible and appropriate both for the environmental conditions to which the steel will be exposed and for the protective coating system used, and — within the capability of the cleaning procedure specified. While these four series of Internat
Scope: This document provides guidance on the usage of analytical colorimetry to support visual assessment of surface preparation grades described in ISO 8501-1:2007, Clause 4. This document provides examples of applications where the use of a colorimeter or spectrophotometer can enable a quick and objective assessment of the preparation grade of the substrate. NOTE The data given in this document was obtained using the methodology described in Annex A.