Hydrometry - Methods of measurement of bedload discharge
Introduction: The knowledge of the rate of sediment transport in a stream is essential in the solution of practically all problems associated with the flow in alluvial channels. The problems include river management, such as design and operation of flood control works, navigation channels and harbours, irrigation reservoirs and canals, and hydroelectric installations. The bedload and suspended load broadly constitute total sediment load. The bedload is the material transported on or near the bed by rolling or sliding (contact load) and the material bouncing along the bed, or moving directly or indirectly by the impact of bouncing particles (saltation load). Knowledge of the bedload-transport rate is necessary in designing reservoir capacity because virtually 100 % of all bedload entering a reservoir accumulates there. Bedload should not enter canals and distributaries and diversion structures should be designed to minimize the transfer of bedload from rivers to canals. The bedload-transport rate can be measured either as mass per unit time or volume per unit time. Volume measurements should be converted to a mass rate. Measurements of mass rate of movement are made during short time periods (seconds, minutes), whereas measurements of volume rates of movement are measured over longer periods of time (hours, days). Regardless of whether the mass or volume rate is measured, the average particle-size distribution of moving material should be determined. Knowledge of particle-size distribution
Scope: This Technical Report reviews the current status of direct and indirect bedload-measurement techniques. The methods are mainly based on grain size distribution of the bedload, channel width, depth, and velocity of flow. This Technical Report outlines and explains several methods for direct and indirect measurement of bedload in streams, including various types of sampling devices. The purposes of measuring bedload-transport rates are to a) increase the accuracy of estimating total sediment load in rivers and deposition in reservoirs, b) gain knowledge of bedload transport that cannot be completely measured by conventional suspended-sediment collection methods, c) provide data to calibrate or verify theoretical transport models, and d) provide information needed in the design of river diversion and entrainment structures. NOTE The units of measurement used in this Technical Report are SI units.