ISO TS 12025-2021 PDF

ISO TS 12025-2021 PDF

Nanomaterials-Quantification of nano-object release from powders by generation of aerosols

$113.50 $227.00 -50%
Product Code: ISO TS 12025
Stock In Stock
Edition: 2ND
Published: 05/2021
Number of Pages: 40
File Size: 1 file, 1 Byte

Available Options

Product Description

Nanomaterials — Quantification of nano-object release from powders by generation of aerosols

Introduction: Industrial powders when subjected to external energy or stress from handling and air flow will release particles entrained in the surrounding air to form aerosols. Aerosols in the nanoscale are more dynamic than micrometre sized particles because of greater sensitivity to physical effects such as Brownian diffusion. Porosity and cohesion of the powder can be much higher than for materials containing larger particles with more resistance to flow and lower volume-specific surface area. Nano-objects in powdered nanostructured materials can dominate relevant properties of the bulk material by particle- particle interactions that form clusters such as agglomerates. Aerosol release characterization consists of three main stages: generation, transport and measurement. In general, to reduce transport losses and aerosol agglomeration, the distance between generation and measurement should be minimized. Although there are potentially many different approaches[35], the generation of an aerosol is usually physically modelled on different representative scenarios (e.g. to simulate typical manual or machine powder handling processes or worst-case highly energetic dispersion). This document is only applicable for measuring the release of nano-objects from powders. This allows comparisons of the nano-object release from different powders using the same generation and measurement system. The choice of the measurement method must take into account the characteristics (e.g. time-related depende

Scope: This document describes methods for the quantification of nano-object release from powders as a result of treatment, ranging from handling to high energy dispersion, by measuring aerosols liberated after a defined aerosolization procedure. Particle number concentration and size distribution of the aerosol are measured and the mass concentration is derived. This document provides information on factors to be considered when selecting among the available methods for powder sampling and treatment procedures and specifies minimum requirements for test sample preparation, test protocol development, measuring particle release and reporting data. In order to characterize the full size range of particles generated, the measurement of nano-objects as well as agglomerates and aggregates is adressed in this document. This document does not include the characterization of particle sizes within the powder. Tribological methods are excluded where direct mechanical friction is applied to grind or abrade the material.

Be the first to write a review for this product.

Write a review

Note: HTML is not translated!
Bad           Good
ISO TS 12025-2021 PDF

ISO TS 12025-2021 PDF

$113.50 $227.00