ISO TS 16422-3-2023 PDF

ISO TS 16422-3-2023 PDF

Pipes and joints made of oriented unplasticized poly(vinyl chloride) (PVC-O) for the conveyance of water under pressure-Part 3: Fittings

$96.50 $193.00 -50%
Product Code: ISO TS 16422-3
Stock In Stock
Edition: 1.
Published: 06/2023
Number of Pages: 26
File Size: 1 file, 1 Byte

Available Options

Product Description

Pipes and joints made of oriented unplasticized poly(vinyl chloride) (PVC-O) for the conveyance of water under pressure — Part 3: Fittings

Introduction: Molecular orientation of thermoplastics results in the improvement of physical and mechanical properties. Orientation is carried out at temperatures well above the glass transition temperature. Orientation of PVC-U pipe-material can be induced by different processes. In general, the following production process is common. A thick-wall tube is extruded (feedstock) and conditioned at the desired temperature. The orientation process is activated in circumferential and axial directions under controlled conditions. After the orientation process, the pipe is cooled down quickly to ambient temperature. The orientation of the molecules creates a laminar structure in the material of the pipe wall. This structure gives the ability to withstand brittle failure emanating from minor flaws in the material matrix or from scratches at the surface of the pipe wall. Improved hoop strength allows reduced wall thickness with material and energy savings. Improved resistance to impact and fatigue also result. The classification depends on the material compound/formulation and stretch ratios used. Therefore, with the classification, these characteristics can be specified or determined. The ISO 16422 series, of which this document is Part 3, specifies the requirements for a piping system made from oriented unplasticized poly(vinyl chloride) (PVC-O) and its components. The piping system is intended to be used for water supply, pressurized drainage and sewerage and irrigation systems to be used underg

Scope: This document specifies the characteristics of solid-wall oriented unplasticized poly(vinyl chloride) (PVC-O) fittings for piping systems intended to be used underground or above ground where protected from direct sunlight, for water supply, buried drainage, sewerage, treated wastewater and irrigation under pressure. This document is applicable to double sockets, repair couplings, reducers and to non- end load bearing elbows only. This document is not applicable to tees, flange adaptors, etc. NOTE For double sockets, repair couplings, and reducers, there are no special fittings designs for end-load bearing applications. However, restrained gaskets can be used for end-load bearing applications. In this case, the requirements of ISO 16422-5 are applicable. This document also specifies the test parameters for the test methods referred to in this document. In conjunction with ISO 16422-1 and ISO 16422-5, this document is applicable to oriented PVC-O pipes with or without an integral socket, intended to be used for the following: a) water mains and services lines; b) conveyance of water for both outside and inside buildings; c) drainage, sewerage and treated wastewater under pressure; d) irrigation under pressure. This document is applicable to piping systems intended for the supply of water under pressure up to and including 25 °C (cold water), intended for human consumption and for general purposes as well as for wastewater under pressure. This document is also applicable to components for the conveyance of water and wastewater up to and including 45 °C. For temperatures between 25 °C and 45 °C, see ISO 16422-2, Figure C.1. The piping system according to this document is intended for the conveyance of cold water up to pressure of 25 bar1) and especially in those applications where special performance requirements are needed, such as impact loads and pressure fluctuations, up to pressure of 25 bar.

Be the first to write a review for this product.

Write a review

Note: HTML is not translated!
Bad           Good
ISO TS 16422-3-2023 PDF

ISO TS 16422-3-2023 PDF

$96.50 $193.00