Test methods for repair materials for water-leakage cracks in underground concrete structures — Part 5: Test method for watertightness
Introduction: This document is linked to ISO/TR 16475. ISO/TR 16475 outlines six basic properties and the required performance levels of water-leakage repair materials; The ISO/TS 16774 series proposes sample testing methods for evaluating the respective properties of the repair materials. The test methods in this document are intended to serve as reference for nations that have not yet developed a test method for the six required performance properties of water-leakage repair materials. Many of the dependent variables outlined in the reference test methods of this document are subject to change in accordance with the environmental conditions (temperature and humidity, chemical solution and concentration, width of movement activity, water pressure or water flow velocity, etc.) outlined in the standards used in respective countries. In this document, ISO/TS 16774-1 and ISO/TS 16774-6, for the purpose of objectively comparing the performance of injected repair materials, artificial cracks of same width, height, and volume are used to control the usage of repair materials for each testing cycle and enable repetition of the same test methods under the same conditions. In this document, target ingredients are limited to injection materials outlined in ISO/TR 16475. These permeability test procedures follow applied conditions outlined in different national testing parameters and requirements. As such, the results are only intended to provide a comparative performance evaluation of the waterproof
Scope: This document specifies a laboratory test method for evaluating watertightness of water-leakage crack repair materials through permeability testing. This document outlines general principles and procedures for the test method. This document does not specify specific variables that control the quantifiable parameters of the testing.