Milk - Determination of the lactoperoxidase activity - Photometric method (Reference method)
Scope: This Technical Specification specifies a photometric method for the determination of the lactoperoxidase activity in milk in amounts exceeding 50 U/l. Terms and definitions For the purposes of this document, the following terms and definitions apply. 2.1 unit of lactoperoxidase activity amount of lactoperoxidase enzyme that catalyses the transformation of 1 µmol of substrate per minute Principle In the presence of any lactoperoxidase enzyme derived from the sample, ABTS [2,2-azino-bis(3-ethylbenzothiazoline-6-sulfonic acid)] is catalytically converted to its radical cation (ABTS•) at pH 6,0 and 25 °C. The amount of (ABTS•) liberated per minute is proportional to the lactoperoxidase activity and measured photometrically at 420 nm. The liberation of the ABTS• is based on the following chemical reaction: lactoperoxidase 2ABTS H O 2H 2ABTS 2H O (1) Reagents Use only reagents of recognized analytical grade, unless otherwise specified, and doubly distilled water or water of equivalent purity. 4.1 Buffer solution, pH 6,0. Dissolve 0,72 g of disodium hydrogenphosphate dihydrate (Na2HPO42H2O) and 3,99 g of potassium dihydrogenphosphate (KH2PO4) in a beaker in a volume of about 450 ml of water. Adjust the pH of the solution, if necessary, to 6,0 0,03 with a dilute sodium hydroxide, potassium hydroxide or phosphoric acid solution. Transfer the solution to a 500 ml volumetric flask (5.6). Make up to the mark with water and mix. NOTE The buffer solution contains 8,09 mmol/l of disodium hydrogenphosphate dihydrate and 58,6 mmol/l of potassium dihydrogenphosphate.