ISO TS 17951-1-2016 PDF

ISO TS 17951-1-2016 PDF

Water quality - Determination of fluoride using flow analysis (FIA and CFA) - Part 1: Method using flow injection analysis (FIA) and spectrometric detection after off-line distillation

$48.00 $96.00 -50%
Product Code: ISO TS 17951-1
Stock In Stock
Edition: 1ST
Published: 07/01/2016
Number of Pages: 20
File Size: 1 file, 501 Bytes

Available Options

Product Description

Water quality - Determination of fluoride using flow analysis (FIA and CFA) - Part 1: Method using flow injection analysis (FIA) and spectrometric detection after off-line distillation

Introduction: Fluorine compounds in waters and effluents exist in various chemical forms, such as fluoride ion, complexes of iron, aluminium, boron and etc., as well as insoluble forms, such as calcium and magnesium fluorides. Excess fluoride can cause bone damage and fluorosis. The manual steam distillation method can be troublesome because of its complexity. It is necessary to ensure conversion of any insoluble fluorides into soluble fluoride for measurement. Flow analysis with colourimetric detection is a rapid cost-effective method of determining of soluble (dissolved) fluoride in the method distillate. This part of ISO 17951 describes FIA methods for flow analysis of fluoride. © ISO 2016 – All rights reserved

Scope: This part of ISO 17951 specifies a method for the determination of fluoride in waters, waste waters and effluents by flow injection analysis (FIA). Any insoluble or complexed fluoride is converted to fluoride ion by a manual distillation procedure from sulfuric/phosphoric acid. Fluoride ion in the distillate is measured using flow analysis with lanthanum alizarin complexone and spectrometric detection. This method is applicable to industrial waste waters, effluents, surface waters, ground waters, leachates. It is not recommended for drinking waters where a distillation step is not required. In this part of ISO 17951, two working ranges are described: — working range I: 0,1 mg/l to 1 mg/l; — working range II: 1 mg/l to 10 mg/l. The specification of the calibration solutions are to be adapted accordingly.

Be the first to write a review for this product.

Write a review

Note: HTML is not translated!
Bad           Good
ISO TS 17951-1-2016 PDF

ISO TS 17951-1-2016 PDF

$48.00 $96.00