Hydraulic fluid power - Hose and hose assemblies - Method of collecting a fluid sample for analyzing the cleanliness of a hose or hose assembly
Introduction: In hydraulic fluid power systems, power is transmitted and controlled through a pressurized liquid within a circuit where piping allows the fluid to flow between components. Part of the piping may consist of hose assemblies, usually manufactured by assembling a length of hose, cut out from a hose coil, with specific connectors at its ends. One of the functions of the hydraulic liquid in a system is to separate and lubricate the moving parts of components. The presence of solid particles produces wear, resulting in loss of efficiency, reduced component life and subsequent unreliability. Thus, hydraulic liquid cleanliness is very important for the system’s uninterrupted operation and long life. The amount of solid contamination present in a hydraulic system at start-up has a great influence on reliability during initial operation and subsequent component life. Components should be cleaned to an appropriate level after manufacturing and prior to use. Hose assemblies are potential sources of contamination because of the bulk hose manufacturing processes, which can be intrinsically dirty, and because of other contaminants coming from assembly operations (hose cutting, dirty connectors, etc.) and/or storage. It may be required to assess the actual built-in solid contamination of hose assemblies before installation (e.g. ISO 4413: 2010, 5.4.6.4, in general requirements for piping). © ISO 2018 – All rights reserved
Scope: This document specifies two methods for collecting a fluid sample to be used to analyse the cleanliness of hydraulic fluid power hoses or hose assemblies within a certain inside diameter and length range (this range includes the majority of hose assemblies of real fluid power applications). The two methods described in this document are intended for collecting only solid particulate contamination; they may not be appropriate for collecting contamination in liquid or grease form. This document is a specific application of ISO 18413:2015, specifically Annexes A and B. The scope of this document does not include providing efficient and effective cleaning methods for hose assemblies. These methods are recommended for statistical validation of other hose cleaning methods, which are more suitable for systematic processing of large production batches. Contamination analysis is excluded from the scope of this document.