ISO TS 19857-2021 PDF

ISO TS 19857-2021 PDF

Paper, board and printing inks-Printability-Laboratory test method for offset ink setting

$96.50 $193.00 -50%
Product Code: ISO TS 19857
Stock In Stock
Edition: 1ST
Published: 06/2021
Number of Pages: 30
File Size: 1 file, 3 Bytes

Available Options

Product Description

Paper, board and printing inks – Printability – Laboratory test method for offset ink setting

Introduction: This document describes a test method to evaluate the ink setting characteristics of a specific ink/ substrate combination in offset lithographic printing. Set-off is the transfer of ink from the front of one sheet to the back or the front of the next sheet. Setting is the process of penetration of liquid ink components of low viscosity into the penetrable substrate. These low-viscosity liquids within the ink are mineral oils, vegetable oils or esters of vegetable oils. By separation from those low-viscous liquids, the remaining ink film solidifies. This is combined with a varying change in the surface tack depending on the inks-varnish system and the time. The surface tack usually increases at the begin of the setting and later-on drops to zero. Setting is either the main drying mechanism for ink systems (e.g. news inks) or part of a multi-channel drying mechanism (e.g. conventional sheet fed offset inks or heatset inks). The laboratory test for setting performs a set-off print of the fresh print to a non-printed substrate at defined times. The ink transfer to the non-printed substrate not only depends on the degree of solidification of the ink by setting, but also on the actual level of tack of the original ink film. Thus, the test result is a combined measure. The absorption properties of the paper are of great influence in offset lithography printing. Inappropriate absorption can lead to numerous printing problems such as ink set-off, bad adhesion, mottling, unpredictable

Scope: This document describes a laboratory test method, using an IGT1)-type or a prüfbau2)-type printability tester, for the preparation of specimens to evaluate the absorption rate of an ink on a substrate in offset lithography by setting-off the printed surface to an unprinted surface. This method describes testing with an amount of ink simulating either single colour or multi-colour printing. The print and the set-off print (counter print) are made with interval times, between print and set-off, common for the target process. This method evaluates a particular ink and substrate combination.

Be the first to write a review for this product.

Write a review

Note: HTML is not translated!
Bad           Good
ISO TS 19857-2021 PDF

ISO TS 19857-2021 PDF

$96.50 $193.00