ISO TS 20458-2023 PDF

ISO TS 20458-2023 PDF

Road vehicles-Design and performance specifications for advanced Pedestrian Legform Impactor (aPLI)

$162.00 $324.00 -50%
Product Code: ISO TS 20458
Stock In Stock
Edition: 1.
Published: 07/2023
Number of Pages: 256
File Size: 1 file, 69 Bytes

Available Options

Product Description

Road vehicles — Design and performance specifications for advanced Pedestrian Legform Impactor (aPLI)

Introduction: This document has been prepared on the basis of the existing design, specifications and performance of advanced pedestrian legform impactor (aPLI) standard build level B (SBL-B). The purpose of this document is to document the design and specifications of this pedestrian legform impactor in a form suitable and intended for worldwide harmonized use. In 2014, aPLI development started, with the aims of defining a globally accepted next-generation pedestrian legform impactor, with enhanced biofidelity and injury assessment capability by implementing an upper mass to represent the influence of the upper body of a pedestrian, and suitable for harmonized use. Participating in the development were research institutes, dummy and instrumentation manufacturers, governments and car manufacturers from around the world. Details are given in Annex A through Annex G and Annex P. aPLI drawings in electronic format are available. Details are given in Annex I and Annex H.  © ISO 2023 – All rights reserved

Scope: This document provides definitions, symbols, mechanical requirements, certification test procedure, electronic subsystem requirements and user’s manual for advanced pedestrian legform impactor (aPLI), a standardized pedestrian legform impactor with an upper mass for pedestrian subsystem testing of road vehicles. It is applicable to impact tests involving: — vehicles of category M1, except vehicles with the maximum mass above 2 500 kg and which are derived from N1 category vehicles and where the driver’s position, R-point, is either forward of the front axle or longitudinally rearwards of the front axle transverse centreline by a maximum of 1 100 mm; — vehicles of category N1, except where the driver’s position, R-point, is either forward of the front axle or longitudinally rearwards of the front axle transverse centreline by a maximum of 1 100 mm; — impacts to the bumper test area as defined by UN R127[1] and UN GTR No.9[2]; — pedestrian subsystem tests involving use of a legform for the purpose of evaluating compliance with vehicle safety standards.

Be the first to write a review for this product.

Write a review

Note: HTML is not translated!
Bad           Good
ISO TS 20458-2023 PDF

ISO TS 20458-2023 PDF

$162.00 $324.00