Assessment of conformity of plastics piping systems for the rehabilitation of existing pipelines — Part 2: Resin-fibre composite (RFC) material
Introduction: System standards dealing with the following applications are either available or in preparation for pipeline rehabilitation: — ISO 11296, Plastics piping systems for renovation of underground non-pressure drainage and sewerage networks; — ISO 11297, Plastics piping systems for renovation of underground drainage and sewerage networks under pressure; — ISO 11298, Plastics piping systems for renovation of underground water supply networks; — ISO 11299, Plastics piping systems for renovation of underground gas supply networks; — ISO 21225, Plastics piping systems for the trenchless replacement of underground pipeline networks. These system standards are distinguished from those for conventionally installed plastics piping systems by the requirement to verify certain characteristics in the as-installed condition, after site processing. This is in addition to specifying requirements for plastics piping system components as manufactured. For the assessment of conformity, three Technical Specifications for pipe lining systems of distinct materials are applicable: — ISO/TS 23818-1, Assessment of conformity of plastics piping systems for the rehabilitation of existing pipelines — Part 1: Polyethylene (PE) material; — ISO/TS 23818-2 (this document), Assessment of conformity of plastics piping systems for the rehabilitation of existing pipelines — Part 2: Resin-fibre composite (RFC) material; — ISO/TS 23818-3, Assessment of conformity of plastics piping systems for the rehabilitation of
Scope: This document provides a scheme for the assessment of conformity of RFC products for the rehabilitation of existing pipelines, in accordance with the applicable parts of ISO 11296, ISO 11297 and ISO 11298, and intended to be included in the manufacturer’s quality plan as part of the quality management system and for the establishment of certification procedures. It applies to cured-in-place pipe (CIPP) products only. It applies to non-pressure pipe liners, and to independent (fully structural, class A) and interactive (semi-structural, class B) pressure pipe liners, as defined in ISO 11295, which do not rely on adhesion to the existing pipeline. NOTE In order to help the reader, summary tables of overall scheme requirements are provided in Annex E.