ISO TS 31657-1-2020 PDF

ISO TS 31657-1-2020 PDF

Plain bearings-Hydrodynamic plain journal bearings under steady-state conditions-Part 1: Calculation of multi-lobed and tilting pad journal bearings

$60.00 $120.00 -50%
Product Code: ISO TS 31657-1
Stock In Stock
Edition: 1.
Published: 06/2020
Number of Pages: 44
File Size: 1 file, 2 Bytes

Available Options

Product Description

Plain bearings — Hydrodynamic plain journal bearings under steady-state conditions — Part 1: Calculation of multi-lobed and tilting pad journal bearings

Introduction: The aim of this document is the operationally-safe design of plain journal bearings for medium or high journal circumferential velocities, UJ , up to approximately 90 m/s by applying a calculation method for oil-lubricated hydrodynamic plain bearings with complete separation of journal and bearing sliding surfaces by a lubricating film. For low circumferential velocities up to approximately 30 m/s usually circular cylindrical bearings are applied. For these bearings a similar calculation method is given in ISO 7902-1, ISO 7902-2 and ISO 7902-3. Based on practical experience the calculation procedure is usable for application cases where specific bearing load times circumferential speed, p U ⋅J , does not exceed approximately 200 MPa·m/s. This document discusses multi-lobed journal bearings with two, three and four equal, symmetrical sliding surfaces, which are separated by laterally-closed lubrication pockets, and symmetrically-loaded tilting-pad journal bearings with four and five pads. Here, the curvature radii, RB , of the sliding surfaces are usually chosen larger than half the bearing diameter, D, so that an increased bearing clearance results at the pad ends. The calculation method described here can also be used for other gap forms, for example asymmetrical multi-lobed journal bearings like offset-halves bearings, pressure-dam bearings or other tilting-pad journal bearing designs, if the numerical solutions of the basic formulas are available for these designs. © ISO 2

Scope: This document specifies the general principles, assumptions and preconditions for the calculation of multi-lobed and tilting-pad journal bearings by means of an easy-to-use calculation procedure based on numerous simplifying assumptions. For a reliable evaluation of the results of this calculation method, it is indispensable to consider the physical implications of these assumptions as well as practical experiences for instance from temperature measurements carried out on real machinery under typical operating conditions. Applied in this sense, this document presents a simple way to predict the approximate performance of plain journal bearings for those unable to access more complex and accurate calculation techniques. The calculation method serves for the design and optimisation of plain bearings, for example in turbines, compressors, generators, electric motors, gears and pumps. It is restricted to steady-state operation, i.e. in continuous operating states the load according to size and direction and the angular velocity of the rotor are constant. Unsteady operating states are not recorded. The stiffness and damping coefficients of the plain journal bearings required for the linear vibration and stability investigations are indicated in ISO/TS 31657-2 and ISO/TS 31657-3.

Be the first to write a review for this product.

Write a review

Note: HTML is not translated!
Bad           Good
ISO TS 31657-1-2020 PDF

ISO TS 31657-1-2020 PDF

$60.00 $120.00