Electrically propelled road vehicles — Functional and safety requirements for power transfer between vehicle and external electric circuit — Part 5: Automatic conductive power transfer
Introduction: This document specifies requirements for the onboard side of an automatic connection system to charge electric vehicles. It gives guidance in terms of safety and compatibility with the offboard side of automatic connection systems. Technological maturity: It is pointed out, that this document has been established in parallel to the technological development of automatic connection systems. Due to the fact that the experience with the technology is very limited, the requirements given in this document do not comprehensively cover all aspects/requirements for an interoperable operation at this stage. Current and future product developments will continuously prove, disprove and refine the requirements of this document. Furthermore, it is worthwhile to mention that at the date of publication of this document, no standard for a vehicle coupler of category 3 (at the underbody of the vehicle) is available. Relation to other parts of the ISO 5474 series: There is no direct relation of content or structure of this document to any other part of the ISO 5474 series (including ISO 5474-1). Wherever needed, other parts of the series are specifically referenced. © ISO 2024 – All rights reserved
Scope: This document defines requirements for the onboard system (vehicle side) related to the automatic connection for conductive alternating current (AC) and/or direct current (DC) power transfer between electrically propelled road vehicles (EVs) and external electric circuits. This document addresses the following aspects: — electrical and mechanical safety requirements; — compatibility requirements; — environmental conditions; — functionality requirements; — test procedures. This document applies to: — EVs supporting automatic connection of a vehicle inlet according to IEC 62196-2, IEC 62196-3, IEC TS 62196-3-1 or IEC TS 633791) (category 1) and — EVs supporting automatic connection of a category 3 vehicle inlet or category 3 plug (typically at the underbody of the vehicle) according to IEC TS 61851-26. NOTE 1 IEC TS 61851-26 does not include automatic connection of vehicle inlets or plugs of category 1 and category 2, that can also be mounted at the underbody of the vehicle. Requirements for EVs equipped with an ACD or ACD counterpart of category 2 are specified in EN 50696 and IEC 634072). Requirements for simultaneous operation of multiple power transfer interfaces are under consideration and not covered in this document. NOTE 2 Requirements for ACD infrastructure, communication sequence and communication interface are specified in IEC 61851-23-1, IEC TS 61851-26 and IEC TS 61851-27. NOTE 3 EMC requirements for vehicles conductively connected to the supply network are defined in IEC 61851-21-1. 1) Under preparation. Stage at the time of publication: IEC TS/CDM 63379:2023. 2) Under preparation. Stage at the time of publication: IEC/CDM 63407:2023. © ISO 2024 – All rights reserved ISO/TS 5474-5:2024(en) 2 Normative references The following documents are referred to in the text in such a way that some or all of their content constitutes requirements of this document. For dated references, only the edition cited applies. For undated references, the latest edition of the referenced document (including any amendments) applies. ISO 5474-13), Electrically propelled road vehicles — Functional requirements and safety requirements for power transfer — Part 1: General requi