ISO TS 6336-4-2019 PDF

ISO TS 6336-4-2019 PDF

Calculation of load capacity of spur and helical gears-Part 4: Calculation of tooth flank fracture load capacity

$113.50 $227.00 -50%
Product Code: ISO TS 6336-4
Stock In Stock
Edition: 1ST
Published: 01/2019
Number of Pages: 36
File Size: 1 file, 1.6 MB

Available Options

Product Description

Calculation of load capacity of spur and helical gears — Part 4: Calculation of tooth flank fracture load capacity

Introduction: The ISO 6336 series consists of International Standards, Technical Specifications (TS) and Technical Reports (TR) under the general title Calculation of load capacity of spur and helical gears (see Table 1). — International Standards contain calculation methods that are based on widely accepted practices and have been validated. — Technical Specifications (TS) contain calculation methods that are still subject to further development. — Technical Reports (TR) contain data that is informative, such as example calculations. The procedures specified in ISO 6336-1 to ISO 6336-19 cover fatigue analyses for gear rating. The procedures described in ISO 6336-20 to ISO 6336-29 are predominantly related to the tribological behaviour of the lubricated flank surface contact. ISO 6336-30 to ISO 6336-39 include example calculations. The ISO 6336 series allows the addition of new parts under appropriate numbers to reflect knowledge gained in the future. Requesting standardized calculations according to the ISO 6336 series without referring to specific parts requires the use of only those parts that are currently designated as International Standards (see Table 1 for listing). When requesting further calculations, the relevant part or parts of the ISO 6336 series need to be specified. Use of a Technical Specification as acceptance criteria for a specific designs need to be agreed in advance between the manufacturer and the purchaser. Table 1 — Parts of the ISO 6336 series (status as of DATE O

Scope: This document describes a procedure for the calculation of the tooth flank fracture load capacity of cylindrical spur and helical gears with external teeth. It is not intended to be used as a rating method in the design and certification process of a gearbox. The formulae specified are applicable for driving as well as for driven cylindrical gears while the tooth profiles are in accordance with the basic rack specified in ISO 53. They can also be used for teeth conjugate to other racks where the actual transverse contact ratio is less than εα = 2,5. The procedure was validated for case carburized[15] gears and the formulae of this document are only applicable to case carburized gears with specifications inside the following limits: — Hertzian stress: 500 N/mm2 ≤ pH ≤ 3 000 N/mm2; — Normal radius of relative curvature: 5 mm ≤ ρred ≤ 150 mm; — Case hardening depth at 550 HV in finished condition: 0,3 mm ≤ CHD ≤ 4,5 mm. This document is not applicable for the assessment of types of gear tooth damage other than tooth flank fracture.

Be the first to write a review for this product.

Write a review

Note: HTML is not translated!
Bad           Good
ISO TS 6336-4-2019 PDF

ISO TS 6336-4-2019 PDF

$113.50 $227.00